PAS302BCW-22S Datasheet, PDF (4/15 Pages) Pixart Imaging Inc. – CMOS VGA DIGITAL IMAGE SENSOR

PAS302BCW-22S
CMOS Image Sensor IC
3. Function Description
3.1 Defect Compensation
The Defect Compensation block can detect the possible defect pixel and replace it with average
output of like-colored pixels from near side of defect pixel. There is no limitation capability of
defect pixel number. This function can be programmed to enable/disable by user.
3.2 Companding Curves
The companding function which means compressing and expanding is used to simulate the
gamma curve and do non-linear transformation before the data is output. There are 4 curves
selected by setting Register Compand_Sel as shown in Fig. 3.1. This function can be
programmed to enable/disable by user.
01

#JU
  




XJUIPVU
DPNQBOEJOH
 YYY YYYY  YYY YYYY 

 YYYY YYYY
 YYYY YYYY
*1

#JU
Figure 3.1 Companding curves programmed by Compand_EnH and Compand_Sel.
3.3 Power Down Mode
The PAS302BCW-22S can be powered down by setting register “Sw_PwrDn” = 1 or by enable
Pwdn pin. The register value will sustain in the power down mode. PAS302BCW-22S supports 2
power down modes:
z Software power downjSet register “Sw_PwrDn” = 1 to power down all the internal block
except I²C^TM .
z Hardware power downjPull Pwdn pin to high to power down the chip. The chip will go into
standby mode.
3.4 Reset Mode
The PAS302BCW-22S can be reseted by setting register “Sw_Reset” = 1 or by enable Reset
pin. PAS302BCW-22S supports 2 reset modes:
z Software resetjSet register “Sw_Reset” = 1 to reset all the I²C^TM registers.
z Hardware resetjPull Reset pin to high to reset the full chip.
Version 2.4, 20 Sep. 2005
PixArt Imaging Inc.
4
E-mail: [e-mail]