PAW3603DH-NF Datasheet, PDF (17/32 Pages) Pixart Imaging Inc. – LOW POWER WIRELESS LASER MOUSE SENSOR

PixArt Imaging Inc.
PAW3603DH-NF
CMOS Laser Mouse Sensor
7.1.2 Read Operation
A read operation, which means that data is going from the mouse sensor to the mouse controller, is always
initiated by the mouse controller and consists of two bytes. The first byte contains the address, is written by the
mouse controller, and has a “0” as its MSB to indicate data direction. The second byte contains the data and is
driven by the mouse sensor. The transfer is synchronized by SCLK. SDIO is changed on falling edges of SCLK
and read on every rising edge of SCLK. The mouse controller must go to a high Z state after the last address
data bit. The mouse sensor will go to the high Z state after the last data bit.
SCLK
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
SDIO
DO N 'T
CARE
0
A6 A5
A4 A3
H i-Z
A2 A1 A0 D7 D6
D5 D4
D3 D2
H i-Z_{_}
D 1 D 0 R/W bit of next
address
SDIO driven by the m ouse controller
SDIO driven by the m ouse sensor
Note "A"
Note "B"
N ote "A " ^{1. The m ouse controller sends address to the m ouse sensor.}
2. T he m ouse controller releases and set SD IO to H i-Z after the last address bit.
SCLK
7
SDIO
A1
8
A0
H i-Z
9
D7
t_HOLD
3us,m in
Note "B" 1. The m ouse sensor sends data to the m ouse controller .
2. T he m ouse sensor releases and set SD IO to H i-Z after the last data bit.
SCLK
16
SD IO
D0
H i-Z
_
1
R/W bit of next address
SDIO driven by the mouse controller
Figure 11. Read Operation
7.2 Re-Synchronous Serial Interface
If the mouse controller and the mouse sensor get out of synchronization, then the data either written or read
from the registers will be incorrect. In such a case, an easy way to solve this condition is to toggle the SCLK
line from high to low to high and wait at least t_SIWTT to reach re-synchronous the parts after an incorrect read.
This method is called by “watchdog timer timeout”. The mouse sensor will reset the serial port but will not reset
the registers and be prepared for the beginning of a new transmission.
t_{S IW TT}
SCLK
1
2
3
4
5
6
7
8
9
1
0
1
1
1
2
1
3
1
4
1
5
1
6
SD IO
t_{R E S Y N C}
1us, m in
H i-Z
_
ADDR ESS (R/W )
DATA
Figure 12. Re-synchronous Serial Interface Using Watchdog Timer Timeout
Note that this function is disabled when the mouse sensor is in the power down mode. If the user uses this
function during the power down mode, it will get out of synchronization. The mouse sensor and the mouse
controller also might get out of synchronization due to following conditions.
All rights strictly reserved any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission.
17
PixArt Imaging Inc.
E-mail: [e-mail]
V1.0, Aug. 2007