PAS6311LT Datasheet, PDF (10/18 Pages) Pixart Imaging Inc. – CMOS VGA DIGITAL IMAGE SESNSOR

PAS6311LT Specification
4.2. Data Transfer Format
4.2.1. Master transmits data to salve ( write cycle )
z S : Start.
z A : Acknowledge by salve.
z P : Stop.
z RW : The LSB of 1^ST byte to decide whether current cycle is read or write cycle. RW = 1 –
Read cycle, RW = 0 – Write cycle.
z SUBADDRESS : The address values of PAS6311LT internal control registers. ( Please refer
to PAS6311LT register description )
During write cycle, the master generates start condition and then places the 1^st byte data that are
combined slave address ( 7 bits ) with a read / write control bit to SDA line. After slave ( PAS6311LT )
issues acknowledgment, the master places 2^nd byte ( Sub Address ) data on SDA line. Again follow the
PAS6311LT acknowledgment, the master places the 8 bits data on SDA line and transmit to PAS6311LT
control register ( address was assigned by 2^nd byte ). After PAS6311LT issue acknowledgment, the master
can generate a stop condition to end of this write cycle. In the condition of multi-byte write, the
PAS6311LT sub-address is automatically increment after each DATA byte transferred. The data and A
cycles is repeat until last byte write. Every control registers value inside PAS6311LT can be
programming via this way.
4.2.2. Slave transmits data to master ( read cycle )
z The sub-address was taken from previous write cycle.
z The sub-address is automatically increment after each byte read.
z Am : Acknowledge by master.
z Note there is no acknowledgment from master after last byte read.
All rights strictly reserved any portion in this paper shall not be reproduced, copied or transformed to any other forms without permission.
10
PixArt Imaging Inc.
E-mail: [e-mail]
v1.5 2007/10/02