English
Language : 

TDA8440 Datasheet, PDF (9/12 Pages) NXP Semiconductors – Switch for CTV receivers
Philips Semiconductors
Switch for CTV receivers
Product specification
TDA8440
PARAMETER
SYMBOL
MIN.
TYP. MAX.
Bus free before start(11)
Start condition set-up time
Start condition hold time
SCL, SDA LOW period
SCL, HIGH period
SCL, SDA rise time
SCL, SDA fall time
Data set-up time (write)
Data hold time (write)
Acknowledge (from TDA8440) set-up time
Acknowledge (from TDA8440) hold time
Stop condition set-up time
tBUF
ts(STA)
th(STA)
tLOW
tHIGH
tr
tf
ts(DAT)
th(DAT)
ts(CAC)
th(CAC)
ts(STO)
4
−
−
4
−
−
4
−
−
4
−
−
4
−
−
−
−
1
−
−
0,3
1
−
−
1
−
−
−
−
2
0
−
−
4
−
−
Notes to the characteristics
1. Also if the supply is switched off.
2. Caused by drive on any other input at maximum level, measured in B = 5 MHz, source impedance
for the used input 75 Ω,
crosstalk = 20 log V-----I-VN----o--m-u---t-a---x-
UNIT
µs
µs
µs
µs
µs
µs
µs
µs
µs
µs
µs
µs
3. S/N = 20 log -V--V--O--O---v---ni--d-o--e--i-so---e--n---r-o-m--i--s˙-s--e---B---(--p=-------p5---)--M--(--2-H----Vz----).
4. Supply voltage ripple rejection = 20 log V----V-r---o-r---ns---u--o--p-u--p-t--pl--y-u----t at f = max. 100 kHz.
5. S/N = 20 log -V--V--O--O---n---n-o--o-i-s--m-e----i-nB-˙-˙-a---=-l---(-2-0---0,--5---k--V-H---)-z--.
6. Caused by drive of any other input at maximum level, measured in B = 20 kHz, source impedance
of the used input = 1 kΩ,
crosstalk = 20 log V-----i-Vn----o-m--u---ta---x- according to DIN 45405 (CCIR 468).
7. f = 20 Hz to 20 kHz.
8. All outputs are short-circuit proof (static).
9. The inputs and output (apart from SDA, SCL and OFF) withstand tests of MIL-STD-883 C. It is advisable to
connected series resistors to these pins.
10. Timings tS, DAT and tH, DAT deviate from the I2C bus specification. After reset has been activated, transmission may
only be started after a 50 µs delay.
11. I2C bus load conditions are as follows:
4kΩ pull-up resistor to + 5 V; 200 pF to GND.
All values are referred to VIH = 3 V and VIL = 1,5 V.
November 1985
9