LP064V1 Datasheet, PDF (7/20 Pages) NXP Semiconductors – LP064V1 LIQUID CRYSTAL DISPLAY

LP064V1 LIQUID CRYSTAL DISPLAY
5. INTERFACE CONNECTIONS
SPECIFICATIONS
TITLE: LP064V1 REV. 1 PAGE 7 OF 7
This LCD employs two interface connections, a 31 pin connector is used for the
module and a three pin connector is used for the integral backlight system. The
electric interface connector is model DF9B-31P-1V, manufactured by Hirose. The
mating connector part number is DF9-31S-1V or equivalent. The pin configuration
for the connector is shown in the table below.
Table 3: MODULE CONNECTOR PIN CONFIGURATION
Pin
Symbol
1
Vss
2
CLK
3
Hsync
4
Vsync
5
Vss
6
R0
7
R1
8
R2
9
R3
10
R4
11
R5
12
Vss
13
G0
14
G1
15
G2
16
G3
17
G4
18
G5
19
Vss
20
B0
21
B1
22
B2
23
B3
24
B4
25
B5
26
Vss
27
DTMG
28
Vdd
29
Vdd
30
OAS
31
NC
Description
Ground
Main clock
Horizontal sync.
Vertical sync.
Ground
Red data
Red data
Red data
Red data
Red data
Red data
Ground
Green data
Green data
Green data
Green data
Green data
Green data
Ground
Blue data
Blue data
Blue data
Blue data
Blue data
Blue data
Ground
Data Timing Signal
Power(+5V)
Power(+5V)
O/A, A/V Selection
No Connection
Notes
Connect to Vss, see Note 1
Connect to Vss, see Note 1
Red data least significant bit(LSB)
Red data most significant bit(MSB)
Connect to Vss, see Note 1
Green data least significant bit(LSB)
Green data most significant bit(MSB)
Connect to Vss, see Note 1
Blue data least significant bit(LSB)
Blue data most significant bit(MSB)
Connect to Vdd, see Note 2
Connect to Vdd, see Note 2
see Note3
Note 1:
Note 2:
Note 3:
Note 4:
All GND (ground) pins should be connected together and to Vss which
should also be connected to the LCD’s metal frame.
All V_DD (power input) pins should be connected together.
This pin is Logic input pin and is connected V_DD (power input) with surge
protection circuit.
DTMG, HSYNC and VSYNC shall be supplied simultaneously.
DATA DISPLAY AG
Industriestrasse 1
D-82110 Germering
MAY 2001
http://www.datadisplay.de
Tel.: [phone]
Fax: [phone]