NX5L2750C_15 Datasheet, PDF (6/16 Pages) NXP Semiconductors – Analog switch with negative swing audio capability

NXP Semiconductors
NX5L2750C
Analog switch with negative swing audio capability
12. Dynamic characteristics
Table 9. Dynamic characteristics
At recommended operating conditions; voltages are referenced to GND (ground = 0 V); for test circuit, see Figure 7.
Symbol Parameter
Conditions
T_amb = 40 C to +85 C
Min
Typ^[1]
Max
Unit
t_en
enable time
nS to nZ; see Figure 5
V_CC = 2.7 V to 3.6 V
V_CC = 3.6 V to 4.3 V
t_dis
disable time
nS to nZ; see Figure 5
V_CC = 2.7 V to 3.6 V
V_CC = 3.6 V to 4.3 V
t_b-m
break-before-make time see Figure 6
V_CC = 2.7 V to 3.6 V
V_CC = 3.6 V to 4.3 V
[2]
-
[3]
-
[2]
-
[3]
-
[4]
15
12
80
160
ns
70
120
ns
25
50
ns
25
50
ns
55
-
ns
45
-
ns
[1] Typical values are measured at T_amb = 25 C.
[2] Typical values are measured at V_CC = 3.3 V.
[3] Typical values are measured at V_CC = 4.3 V.
[4] Guaranteed by design.
12.1 Waveform and test circuits
nS input
V_I
GND
nY1 connected to V_EXT
nZ output
V_OH
OFF to HIGH
HIGH to OFF
GND
nY0 connected to V_EXT
nZ output
V_OH
HIGH to OFF
OFF to HIGH
GND
V_M
t_en
V_X
t_dis
V_X
t_dis
V_X
t_en
V_X
001aak762
Fig 5.
Measurement points are given in Table 10.
Logic level: V_OH and V_OLare typical output voltage levels that occur with the output load.
Enable and disable times
Table 10. Measurement points
Supply voltage
Input
V_CC
V_M
V_I
2.7 V to 4.3 V
0.5V_CC
V_CC
Output
V_X
0.9V_OH
NX5L2750C
Product data sheet
All information provided in this document is subject to legal disclaimers.
Rev. 2 — 7 May 2014
© NXP Semiconductors N.V. 2014. All rights reserved.
6 of 16