GTL2014 Datasheet, PDF (4/15 Pages) NXP Semiconductors – 4-bit LVTTL to GTL transceiver

Philips Semiconductors
GTL2014
4-bit LVTTL to GTL transceiver
8. Limiting values
Table 6: Limiting values
In accordance with the Absolute Maximum Rating System (IEC 60134). ^[1]
Voltages are referenced to GND (ground = 0 V).
Symbol Parameter
Conditions
Min
Max
Unit
V_CC
DC supply voltage
I_IK
input clamping diode current V_I < 0 V
V_I
DC input voltage
A port
B port
−0.5
+4.6
V
-
−50
mA
−0.5 ^[2] +7.0
V
−0.5 ^[2] +4.6
V
I_OK
output diode clamping current A port; V_O < 0 V
-
−50
mA
V_O
DC output voltage
output in OFF or
HIGH state; A port
−0.5 ^[2] +7.0
V
output in OFF or
HIGH state; B port
−0.5 ^[2] +4.6
V
I_OL
current into any output in
A port
the LOW state
B port
-
32
mA
-
80
mA
I_OH
current into any output in
A port
the HIGH state
-
−32
mA
T_stg
storage temperature range
[3] _−60
+150
°C
[1] Stresses beyond those listed may cause permanent damage to the device. These are stress ratings only
and functional operation of the device at these or any other conditions beyond those indicated under
Section 9 “Recommended operating conditions” is not implied. Exposure to absolute-maximum-rated
conditions for extended periods may affect device reliability.
[2] The input and output negative voltage ratings may be exceeded if the input and output clamp current ratings
are observed.
[3] The performance capability of a high-performance integrated circuit in conjunction with its thermal
environment can create junction temperatures which are detrimental to reliability. The maximum junction
temperature of this integrated circuit should not exceed 150 °C.
9397 750 13534
Product data sheet
Rev. 01 — 19 May 2005
© Koninklijke Philips Electronics N.V. 2005. All rights reserved.
4 of 15