NX3DV2567_15 Datasheet, PDF (1/20 Pages) NXP Semiconductors – Low-ohmic four-pole double-throw analog switch

NX3DV2567
Low-ohmic four-pole double-throw analog switch
Rev. 2 — 9 November 2011
Product data sheet
1. General description
The NX3DV2567 is a four-pole double-throw analog switch (4PDT) optimized for
switching WLAN-SIM supply, data and control signals. It has one digital select input (S)
and four switches each with two independent input/outputs (nY0 and nY1) and a common
input/output (nZ). Schmitt trigger action at S makes the circuit tolerant to slower input rise
and fall times across the entire V_CC range from 1.4 V to 4.3 V.
A low input voltage threshold allows pin S to be driven by lower level logic signals without
significant increase in supply current I_CC. This makes it possible for the NX3DV2567 to
switch 4.3 V signals with a 1.8 V digital controller, eliminating the need for logic level
translation.
The NX3DV2567 allows signals with amplitude up to V_CC to be transmitted from nZ to nY0
or nY1; or from nY0 or nY1 to nZ..
2. Features and benefits
 Wide supply voltage range from 1.4 V to 4.3 V
 Very low ON resistance for supply path:
 0.5  (typical) at V_CC = 1.8 V
 0.45  (typical) at V_CC = 2.7 V
 Low ON resistance for data path:
 7  (typical) at V_CC = 1.8 V
 6  (typical) at V_CC = 2.7 V
 Low ON capacitance for data path
 Wide 3 db bandwidth > 160 MHz
 Break-before-make switching
 High noise immunity
 ESD protection:
 HBM JESD22-A114F Class 3A exceeds 4000 V
 HBM JESD22-A114F Class 3A I/O to GND exceeds 7000 V
 CDM AEC-Q100-011 revision B exceeds 1000 V
 CMOS low-power consumption
 Latch-up performance exceeds 100 mA per JESD 78B Class II Level A
 1.8 V control logic at V_CC = 3.6 V
 Control input accepts voltages above supply voltage
 Very low supply current, even when input is below V_CC
 High current handling capability (350 mA continuous current under 3.3 V supply for
supply path switch)