PI3WVR12412 Datasheet, PDF (5/13 Pages) Pericom Semiconductor Corporation – HDMI 2.0, DisplayPort 1.2 Video Switch

PI3W VR12412
HDMI 2.0, DisplayPort 1.2 Video Switch
Maximum Ratings
(Above which useful life may be impaired. For user guidelines, not tested.)
Note: Stresses greater than those listed under MAXI-
Storage Temperature ........................................................... –65°C to +150°C MUM RATINGS may cause permanent damage to
Supply Voltage to Ground Potential ....................................–0.5V to +4.2V the device. This is a stress rating only and functional
DC Input Voltage .......................................................................–0.5V to V_DD ^{operation of the device at these or any other conditions}
DC Output Current ..............................................................................120mA ^{above those indicated in the operational sections of this}
Power Dissipation .................................................................................... 0.5W ^{specification is not implied. Exposure to absolute maxi-}
mum rating conditions for extended periods may affect
reliability.
DC Electrical Characteristics for Switching over Operating Range
(T_A = –40°C to +105°C, V_DD = 3.3V ±10%)
Parameter
Description
Test Conditions⁽¹⁾
VIH
Input HIGH Voltage (SEL & OE)
Guaranteed HIGH level
VIL
Input LOW Voltage (SEL & OE)
Guaranteed LOW level
VIK
Clamp Diode Voltage (HS Channel) V_DD = Max., I_IN = –18mA
VIK
Clamp Diode Voltage (DDC/ AUX,
Cntrl )
V_DD = Max., I_IN = –18mA
IIH
Input HIGH Current
V_DD = Max., V_IN = V_DD
IIL
Input LOW Current
V_DD = Max., V_IN = GND
I_{OFF_SB}
R_{ON_HS}
R_{ON_DDC/ AUX}
R_{ON_HPD}
V_{DDC/ AUX_SS}
V_{HPD_I}
V_{HPD_O}
I/O leakage when part is off for side-
band signals only (DDC/ AUX, HPD)
V_DD = 0V, V_INPUT = 0V to 3.6V
On resistance between input to out-
put for high speed signals
V_INPUT,cm = 0V to 3.4V,
V_INPUT,diff < 1.2V_p-p,diff,
V_DD = 3.0V, I_INPUT = 20mA
On resistance between input to
output for side-band signals (DDC/
AUX)
V_DD = 3.0V, Vinput = 0 to 3.3V,
I_INPUT = 20mA
On resistance between input to out- V_DD = 3.0V, Vinput = 0 to 3.0V,
put for HPD channel
I_INPUT = 20mA
Signal Swing Tolerance in DDC/
AUX path
V_DD = 3.0V
Input voltage on HPD path
Output voltage tolerance on HPD
path
HPD input from 3.3V to 5.25V
Min
1.5
–0.5
Typ⁽²⁾
–1.6V
–0.7
11
7
7
3.3
Max
0.75
–1.8
–1.5
±5
±5
20
3.6
5.5
3.6
Units
V
µA
Ohm
Ohm
Ohm
V
V
V
14-0056
5
www.pericom.com 04/29/14