PI3HDMI1310-A Datasheet, PDF (5/8 Pages) Pericom Semiconductor Corporation – HDMI Switch with non-blocking EQ Circuitry

PI3HDMI1310-A
HDMI™ Switch with non-blocking EQ Circuitry
DC Electrical Characteristics for Switching over Operating Range (T_A = –40°C to +85°C, V_DD =
3.3V ±10%)
Parameter Description
Test Conditions⁽¹⁾
Min
Typ⁽²⁾
IIH
Input HIGH Current
V_DD = Max., V_IN = V_DD
IIL
Input LOW Current
V_DD = Max., V_IN = GND
I_OFF
Off Leakage Current, for high
speed channels only
Vinput = 3.6V, V_DD = 0V
Status Pins (HPD_SINK)
VIH
LVTTL Input HIGH Voltage
VIL
LVTTL Input LOW Voltage
RP
Pull-down Resistance
V_DD50 = 5.0V
2
GND
100k
Max
±5
±5
50
5.3
0.8
Power Supply Characteristics
Parameters Description
Test Conditions⁽¹⁾
Min.
Typ.⁽²⁾ Max.
I_DD
I_DDQ
Operating Power Supply Current
V_DD = Max., V_SELx = GND or
V_DD
Standby Supply Current
OE - High
6
10
3
5
Units
µA
V
Ohm
Units
mA
Dynamic Electrical Characteristics Over the Operating Range (T_A= -40º to +85ºC,
V_DD = 3.3V ±10%, GND=0V)
Parameter Description
Test Conditions
Typ.
Min ⁽²⁾
Max
X_TALK
Crosstalk on High Speed Channels
See Fig. 3 for Measure- ^{f= 1.13 GHz}
ment Setup
f = 825 MHz
-34
-36
O_IRR
OFF Isolation on High Speed
Channels
See Fig. 2 for Measure- ^{f= 1.13 GHz}
ment Setup
f = 825 MHz
-28
-32
I_LOSS
BW
DR = 1.54Gbps
DR = 2.0Gbps
Differential Insertion Loss on High
Speed Channels (see figure 1)
DR = 2.25Gbps
DR = 3.0Gbps
DR = 3.4Gbps
-3dB BW for TMDS channels
-1.5
-1.73
-1.82
-1.99
-2.08
3.0
Status Pins (HPD) - open drain output buffer
V_OL(TTL)
TTL Low-level output voltage
I_OL = 4mA
0.4
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V_DD = 3.3V, T_A = 25°C ambient and maximum loading.
3. Substrate diode voltage drop. For testing reference.
Units
dB
dB
GHz
V
12-0196
5
www.pericom.com 01/25/13