 English |
|
|
|
|
|
|
|
| PI3A114-A Datasheet, PDF (4/10 Pages) Pericom Semiconductor Corporation – Low–Voltage, 4:1 Mux/Demux with Low-Swing Control Inputs | |||
| |||
| ◁ |
PI3A114-A
Low-Voltage, 4:1 Mux/Demux
with Low-Swing Control Inputs
DC Electrical Characteristics +3.3V Supply
(VDD = 3.3V, TA = â40°C to 85°C, unless otherwise noted.)
Parameter
Description
Test Conditions
Analog Switch
Y, Ax
Analog Signal Range
RON
âRON
On-Resistance
On-Resistance Match
Between Channels
IY = 100mA, VIN = 0 to VDD
IY = 100mA, VIN = 0.5VDD
RONF
On-Resistance Flatness
THD
Total Harmonic Distortion
Control Inputs(1)
VIH Input HIGH Voltage
VIL Input LOW Voltage
IIH
Input HIGH Current
IIL
Input LOW Current
IOZH
High Impedance Output
Current
IY = 100mA, VIN = 0 to VDD
Load = 100KΩ , VIN = 0.5VDD , Frequency = 20Hz
to 20KHz
Guaranteed Logic HIGH Level
Guaranteed Logic LOW Level
VDD = Max., VIN = VDD
VDD = Max., VIN = GND
0 ⤠IN, YN ⤠VDD
VIK Clamp Diode Voltage
VDD = Min., IIN = â18mA
Min. Typ(2) Max.
-0.3
VDD
5
0.2
0.6
0.03
1.5
â0.5
0.8
±1
±1
±1
â1.2
Units
V
Ω
%
V
μA
V
Notes:
1. For digital control inputs EN, S0, S1.
2. For Max. or Min. conditions, use appropriate value speciï¬ed under Electrical Characteristics for the applicable device.
2. Typical values are at VDD = 3.3V, TA = 25°C ambient and maximum loading.
3. Measured by the voltage drop between A and Y pin at indicated current through the switch. On-Resistance is determined by the lower of the
voltages on the two (I,Y) pins.
Power Supply Characteristics, 3.3V Supply
Parameters
Description
Test Conditions(1)
Min. Typ.(2) Max.
ICC
Quiescent Power Supply Current
VDD = Max.
VIN = GND
or VDD
0.1
9.0
Notes:
1. For Max. or Min. conditions, use appropriate value speciï¬ed under Electrical Characteristics for the applicable device.
2. Typical values are at VDD = 3.3V, +25°C ambient.
3. Control inputs only; A and Y pins do not contribute to ICC.
Units
μA
08-0231
4
PS8962B
10/21/08
|
▷ |
German
Russian
Spanish
Italian
Polish
Chinese
Japanese
Korean
French
Portuguese