PI3A114-A Datasheet, PDF (3/10 Pages) Pericom Semiconductor Corporation – Low–Voltage, 4:1 Mux/Demux with Low-Swing Control Inputs

PI3A114-A
Low-Voltage, 4:1 Mux/Demux
with Low-Swing Control Inputs
DC Electrical Characteristics +1.8V Supply
(V_DD = 1.8V, T_A = –40°C to 85°C, unless otherwise noted.)
Parameter
Description
Test Conditions
Min. Typ.⁽²⁾ Max. Units
Analog Switch
Y, Ax
R_ON
Analog Signal Range
On-Resistance
I_Y = 100mA, V_IN = 0 to V_DD
-0.3
V_DD V
9
∆R_ON
On-Resistance Match
Between Channels
I_Y = 100mA, V_IN = 0.5V_DD
0.6 Ω
R_ONF
On-Resistance Flatness
THD
Total Harmonic Distortion
Control Inputs⁽¹⁾
I_Y = 100mA, V_IN = 0 to V_DD
Load = 100KΩ , V_IN = 0.5V_DD , Frequency = 20Hz
to 20KHz
5
0.03
%
V_IH Input HIGH Voltage
V_IL Input LOW Voltage
I_IH
Input HIGH Current
Guaranteed Logic HIGH Level
Guaranteed Logic LOW Level
V_DD = Max., V_IN = V_DD
1.5
V
–0.5
0.8
±1
I_IL
I_OZH
Input LOW Current
High Impedance Output
Current
V_DD = Max., V_IN = GND
0 ≤ I_N, Y_N ≤ V_DD
±1
μA
±1
V_IK Clamp Diode Voltage
V_DD = Min., I_IN = –18mA
–1.2 V
Notes:
1. For digital control inputs EN, S0, S1.
2. Typical values are at V_DD = 1.8V, T_A = 25°C ambient and maximum loading.
3. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
4. Measured by the voltage drop between A and Y pin at indicated current through the switch. On-Resistance is determined by the lower of the
voltages on the two (I,Y) pins.
Power Supply Characteristics +1.8V Supply
Parameters
Description
Test Conditions⁽¹⁾
Min. Typ.⁽²⁾ Max.
I_CC
Quiescent Power Supply Current
V_DD = Max.
V_IN = GND
or V_DD
0.1
9.0
Notes:
1. Control inputs only; A and Y pins do not contribute to I_CC.
2. Typical values are at V_DD = 1.8V, T_A = 25°C ambient and maximum loading.
3. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device.
Units
μA
08-0231
3
PS8962B
10/21/08