PI3USB411 Datasheet, PDF (3/16 Pages) Pericom Semiconductor Corporation – 3.3V, USB 2.0 High-Speed Signal Switch w/ Low THD Channels for Audio Signals

PI3USB411
3.3V, USB 2.0 High-Speed Signal Switch
with Low THD Channels for Audio Signals
Dynamic Electrical Characteristics Over the Operating Range
(T_A = –40°C to +85°C, V_CC = 3.3V ±10%, GND = 0V) (Only related to pins 1, 2, 4, 14, 15)
Parameters⁽¹⁾
Description
Test Conditions⁽³⁾
X_TALK
O_IRR
Crosstalk
OFF Isolation
R_L = 100Ω, f = 250 MHz
BW
Bandwidth -3dB
R_L = 100Ω
Typ.⁽⁴⁾
-31
-39
700
Units
dB
MHz
Switching Characteristics (Only related to pins 1, 2, 4, 14, 15)
Parameters
Description
t_PD
t_PZH, t_PZL
t_PHZ, t_PLZ
t_SK(p)
Propagation Delay⁽²⁾
Line Enable Time - USB_EN to D_I, D_O
Line Disable Time - USB_EN to D_I, D_O
Skew between opposite transitions of the same output (t_PHL
- t_PLH) ⁽²⁾
Test ⁽³⁾
Conditions
Min. Typ.⁽⁴⁾ Max. Units
0.25
0.5
15.0
0.5
9.0 ^ns
0.1 0.2
Power Supply Characteristics
Parameter
Description
I_CC
Power Supply Current
Test Conditions⁽³⁾
V_{CC = Max,} V_{IN =} GND or V_CC
Min. Typ. Max. Units
800 µA
Notes for Page 3:
1. Guaranteed by design.
2. The switch contributes no propagational delay other than the RC delay of the On-Resistance of the switch and the load capacitance. The time
constant for the switch alone is of the order of 0.25ns for 10pF load. Since this time constant is much smaller than the rise/fall times of typical
driving signals, it adds very little propagational delay to the system. Propagational delay of the bus switch when used in a system is determined
by the driving circuit on the driving side of the switch and its interactions with the load on the driven side.
3. For max. or min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
4. Typical values are at V_CC = 3.3V, T_A = 25C ambient and maximum loading.
06-0078
3
PS8817A
06/06/06