PI3USB10M Datasheet, PDF (2/6 Pages) Pericom Semiconductor Corporation – 4.2V, Wide Bandwidth, 2-Channel 2:1 Mux/DeMux USB 2.0 Switch w/ Single Select

PI3USB10M
4.2V, Wide Bandwidth, 2-Channel,
2:1 Mux/DeMux USB 2.0 Switch with Single Select
Maximum Ratings
(Above which useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ......................................... –65°C to +150°C
Supply Voltage to Ground Potential .................... –0.5V to +4.0V
DC Input Voltage ................................................. –0.5V to +5.5V
DC Output Current ........................................................... 120mA
Power Dissipation ................................................................ 0.5W
Note: Stresses greater than those listed under MAXIMUM RAT-
INGS may cause permanent damage to the device. This is a stress
rating only and functional operation of the device at these or any other
conditions above those indicated in the operational sections of this
specification is not implied. Exposure to absolute maximum rating
conditions for extended periods may affect reliability.
DC Electrical Characteristics for USB 2.0 Switching over Operating Range
(T_A = –40°C to +85°C, V_CC = 3.0 - 4.4V)
Paramenter
Description
Test Conditions⁽¹⁾
Min.
Typ.⁽²⁾ Max. Units
V_IH
Input HIGH Voltage
V_IL
Input LOW Voltage
Guaranteed
V_CC = 4.2V
2.0
HIGH level
V_CC = 3.3V
1.6
Guaranteed HIGH level
V
0.8
V_IK
Clamp Diode Voltage
V_CC = Max., I_IN = –18mA
-0.7 -1.2
I_IH
Input HIGH Current
I_IL
Input LOW Current
V_CC = Max., V_IN = VCC
V_CC = Max., V_IN = GND
±5
μA
±5
R_ON
Switch On-Resistance⁽³⁾
V_CC = Min., 1.25V ≤ V_IN ≤ V_CC,
I_IN = –40mA
4.0 6.5
R_FLAT(ON) On-Resistance Flatness⁽³⁾
V_CC = Min., V_IN @ 1.5V and
V_CC I_IN = -40mA
1.0
Ω
ΔR_ON
On-Resistance match from cen- V_CC = Min., 1.5V ≤ V_IN ≤ V_CC,
ter ports to any other port⁽³⁾
I_IN = -40mA
0.9 2.0
Notes:
1. For max. or min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. V_CC = 3.0 - 4.4V, T_A = 25°C ambient and maximum loading.
3. Measured by the voltage drop between Y and In pin at indicated current through the Switch-On-Resistance is determined by the lower ofthe
voltages on the two (Y, In) pins.
Power Supply Characteristics (V_CC = 3.0 - 4.4V)
Parameters
Description
Test Conditions⁽¹⁾
Min. Typ. Max.
I_CC
Quiescent Power Supply Current V_CC = Max., V_IN = GND or V_CC
800
Notes:
1. For max. or min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
Units
µA
06-0014
2
PS8799B
03/16/06