|
PI3EQX501B Datasheet, PDF (2/7 Pages) Pericom Semiconductor Corporation – 5.0Gbps, 1-channel, USB3.0 ReDriver | |||
|
◁ |
PI3EQX501B
5.0Gbps, 1-Channel, USB3.0 ReDriverâ¢
Pin Description
Pin # Pin Name
1
VDD
2,3
RXP, RXN
4
TRI
5
EQ
7, 6
TXP, TXN
8
DE
Center Pad GND
Type
Power
Input
Input
Input
Description
3.3V power supply
CML input channels. With Selectable input termination between 50⦠to internal Vbias or
60k⦠to ground.
Set the state of chip; With internal 200k⦠pull-down resistor
âHighâ means NO receiver termination detection and for debug mode.
âLowâ means normal operation mode with receiver termination detection.
Set the equalization of the channels. Tri-level input pin. With internal 100k⦠pull-up resis-
tor and 100K⦠pull-down resistor.
Output Selectable output termination between 50⦠to internal Vbias or 2k⦠to internal Vbias.
Input
Set de-emphasis of output CML buffer. Tri-level input pin. With internal 100k⦠pull-up
resistor and 100k⦠pull-down resistor.
GND Supply Ground.
Power Management
Notebooks, netbooks, tablets and other power sensitive consumer devices require judicious use of power in order to maximize battery
life. In order to minimize the power consumption of our devices, Pericom has added an additional adaptive power management feature.
When a signal detector is idle for longer than 1.3ms, the channel will move to low power mode.
In the low power mode, the signal detector will still be monitoring the input channel. If a channel is in low power mode and the input
signal is detected, it will wake-up immediately. If a channel is in low power mode and the signal detector is idle longer than 6ms, the
receiver detection loop will be active again. If load is not detected, then the Channel will move to Device Unplug Mode and monitor
the load continuously. If load is detected, it will return to Low Power Mode and receiver detection will be active again per 6ms.
15-0046
2
www.pericom.com 04/08/15
|
▷ |