PI2PCIE412-D Datasheet, PDF (2/9 Pages) Pericom Semiconductor Corporation – Enhanced, 1.8V, PCI Express Compliant, 4-Differential Channel, 2:1 Mux/DeMux Switch, w/ Single Enable

PI2PCIE412-D
Enhanced, 1.8V, PCI Express Compliant,
4-Differential Channel, 2:1 Mux/DeMux Switch
Maximum Ratings
(Above which useful life may be impaired. For user guidelines, not tested.)
Storage Temperature ....................................................–65°C to +150°C
Supply Voltage to Ground Potential ................................–0.5V to +2.5V
DC Input Voltage ...............................................................–0.5V to V_CC
DC Output Current ....................................................................... 120mA
Power Dissipation ........................................................................... 0.5W
Note: Stresses greater than those listed under MAXIMUM
RATINGS may cause permanent damage to the device. This
is a stress rating only and functional operation of the device
at these or any other conditions above those indicated in the
operational sections of this specification is not implied. Expo-
sure to absolute maximum rating conditions for extended
periods may affect reliability.
DC Electrical Characteristics for Switching over Operating Range (T_A = –40°C to +85°C, V_CC = 1.5V to 2.0V)
Paramenter
Description
Test Conditions⁽¹⁾
Min
Typ⁽²⁾
Max Units
VIH
Input HIGH Voltage
Guaranteed HIGH level
0.65 x V_CC
VIL
Input LOW Voltage
Guaranteed LOW level
–0.5
0.35 x V_CC V
VIK
Clamp Diode Voltage
V_CC = Max., I_IN = –18mA
–0.7
–1.2
IIH
Input HIGH Current
V_CC = Max., V_IN = V_CC
IIL
Input LOW Current
V_CC = Max., V_IN = GND
±5
µA
±5
Power Supply Characteristics
Parameters
Description
I_CC
Quiescent Power Supply Current
Test Conditions⁽¹⁾
V_CC = Max., V_IN = GND or V_CC
Min.
Typ.⁽²⁾
200
Max.
Units
µA
Dynamic Electrical Characteristics Over the Operating Range (TA= -40º to +85ºC, VCC = 1.8V±10%, GND=0V)
Parameter
Description
Test Conditions
Min. Typ.⁽²⁾ Max. Units
X_TALK
Crosstalk
See Fig. 1 for Measurement Setup, f = 10 MHz
-65
dB
O_IRR
OFF Isolation
See Fig. 2 for Measurement Setup, f = 10 MHz
-65
Notes:
1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type.
2. Typical values are at V_CC = 1.8V, T_A = 25°C ambient and maximum loading.
2
PS8788B
01/23/06