English
Language : 

PI3A3160C Datasheet, PDF (1/7 Pages) Pericom Semiconductor Corporation – 3.0V, SOTiny™ 0.8Ω Dual SPDT Analog Switch with -1.0V to 4.2V Operating Range
PI3A3160C
3.0V, SOTiny™ 0.8Ω Dual SPDT Analog Switch
with -1.0V to 4.2V Operating Range
Features
• Analog Signal Range: -1.0V to VCC when switch is “ON”
• -1.0V Undershoot Protection when switch is “OFF”
• CMOS Technology for Bus and Analog Applications
• Low On-Resistance: 0.8Ω (+3.3V Supply)
• Wide VCC Range: 1.5V to 4.2V ±10%
• Low Power Consumption : 5µW
• Rail-to-Rail switching throughout Signal Range
• Fast Switching Speed: 50ns max. at 3.3V
• High Off Isolation: –50dB at 1 MHz
• -45dB (1 MHz) Crosstalk Rejection Reduces Signal Distortion
• Break-Before-Make Switching
• Extended Industrial Temperature Range: –40°C to 85°C
• Packaging: (Pb-free & Green)
–12-contact TDFN (ZE)
–12-contact TDFN (ZG)
Description
The PI3A3160C is a high-bandwidth, fast Dual single-pole double-
throw (SPDT) CMOS switch. It can be used as an analog switch or
as a low-delay bus switch. Specified over a wide operating power
supply voltage range, 1.5V to 4.2V ±10%, the switch has a typical
On-Resistance of 0.8Ω at 3.3V.
Break-before-make switching prevents both switches from being
enabled simultaneously. This eliminates signal disruption during
switching.
Control inputs, IN, tolerates input drive signals up to 3.3V, inde-
pendent of supply voltage.
PI3A3160C is a lower voltage and On-Resistance replacement
for the PI5A3158.
Block Diagram / Pin Configuration
COM0 1
12 VCC0
Applications
• Cell Phones
• PDAs
• Portable Instrumentation
• Battery Powered Communications
• Computer Peripherals
Pin Description
Pin
Number Name(1,2,3)
8, 11
NOx
3, 6
GNDx
2, 5
NCx
1, 4
COMx
9, 12
7, 10
VCCx
INx
Description
Data Port (Normally Open)
Ground
Data Port (Normally Closed)
Common Output/Data Port
Positive Power Supply(1)
Logic Control
Notes:
1. X = 0 or 1
2. VCC0 and VCC1 are not internally connected. Each must be
powered seperately.
3. GND0 and GND1 are not internally connected. Each must be
powered seperately.
NC0 2
GND0 3
COM1 4
NC1 5
GND1 6
Function Table
Logic Input
0
1
11 NO0
10 IN0
9 VCC1
8 NO1
7 IN1
Function
NCx Connected to COMx
NOx Connected to COMx
PS8795B
02/24/06
1