D-300-01 Datasheet, PDF (6/7 Pages) PANDUIT CORP. – CAP, SPLICE ENCAPSULATION

SPECIFICATION CONTROL DRAWING
Property
Dimensions
Dimension Recovery
Property
Insulation Resistance
Temperature Cycling
TABLE 2
REQUIREMENTS FOR FINISHED CAP
Test Group A – Five Caps
Unit
Requirement
Inches
Inches
Sheet 1
Sheet 1
Test Group B – Fifteen Specimens
Unit
Requirement
Megaohms
5000 minimum
Method of Test
ASTM D 876
Section 4.4.2
Method of Test
Section 4.4.3
Section 4.4.5
Followed by test for:
Insulation Resistance
Dielectric Withstanding Voltage
Property
Insulation Resistance
Heat Aging
Megaohms
Volts
5000 minimum
1500 (rms)
Test Group C – Fifteen Specimens
Unit
Requirement
Megaohms
5000 minimum
Section 4.4.3
Section 4.4.4
Method of Test
Section 4.4.3
Followed by test for:
Insulation Resistance
Dielectric Withstanding Voltage
Property
Insulation Resistance
Altitude Immersion
Megaohms
Volts
5000 minimum
1500 (rms)
Test Group D – Fifteen Specimens
Unit
Requirement
Megaohms
5000 minimum
Section 4.4.3
Section 4.4.4
Method of Test
Section 4.4.3
Section 4.4.7
Followed by test for:
Insulation Resistance
Dielectric Withstanding Voltage
Property
Corrosive Effect
Flammability
Megaohms
Volts
5000 minimum
1500 (rms)
Test Group E– Two Caps
Unit
Requirement
Non-Corrosive
Test Group F – Ten Assemblies
Self extinguishing
within 30 seconds
Section 4.4.3
Section 4.4.4
Method of Test
Section 4.4.8
Section 4.4.9
307 Constitution Drive Menlo Park, CA 94025, USA
Wire and
Harnessing
Products
TITLE :
CAP, SPLICE ENCAPSULATION
UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS.
INCHES DIMENSIONS ARE BETWEEN BRACKETS.
DOCUMENT NO.: D-300-01/-03
TOLERANCES:
0.00 N/A
0.0 N/A
0 N/A
ANGLES: N/A
ROUGHNESS IN
MICRON
Tyco Electronics reserves the right to amend
this drawing at any time. Users should
evaluate the suitability of the product for
their application.
DCR NUMBER:
D010043
REPLACES:
N/A
DRAWN BY:
M. FORONDA
DATE:
15-Feb.-01
PROD. REV.
SEE TABLE
DOC ISSUE: SCALE:
1
None
SIZE:
A
SHEET:
6 of 7
If this document is printed it becomes uncontrolled. Check for the latest revision.