D-300-01 Datasheet, PDF (5/7 Pages) PANDUIT CORP. – CAP, SPLICE ENCAPSULATION

SPECIFICATION CONTROL DRAWING
TABLE 1
REQUIREMENTS FOR MOLDED COMPONENT
(continued)
Property
Hardness
Low Temperature Flexibility
4 hours @ -55°C (-67°F)
Heat Shock
4 hours @ 225°C (437°F)
Heat Aging
Followed by test for:
Tensile Strength
Ultimate Elongation
Flammability
Fungus Resistance
Water Absorption
24 hours @ 25°C (77°F)
Solvent Resistance
24 hours @ 25°C (77°F) in
JP-4 Fuel
Skydrol* 500
Hydraulic Fluid (MIL-H-5606)
Aviation Gasoline (100/130)
Water
Unit
Shoe D
psi
percent
percent
Requirement
50±10
No cracking
Method of Test
ASTM D 2240
Section 4.3.2
No Dripping, flowing or
cracking
Section 4.3.3
Section 4.3.4
Procedures A and B
1200 minimum
200 minimum
Non-burning
Rating of 1 or less
0.2 maximum
Section 4.3.1
(ASTM D 412)
ASTM D 635
ASTM D 876
ASTM D 570
Procedure A
Section 4.3.5
Followed by test for:
Tensile Strength
Ultimate Elongation
psi
percent
1200 minimum
200 minimum
Section 4.3.1
(ASTM D 412)
307 Constitution Drive Menlo Park, CA 94025, USA
Wire and
Harnessing
Products
TITLE :
CAP, SPLICE ENCAPSULATION
UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS.
INCHES DIMENSIONS ARE BETWEEN BRACKETS.
DOCUMENT NO.: D-300-01/-03
TOLERANCES:
0.00 N/A
0.0 N/A
0 N/A
ANGLES: N/A
ROUGHNESS IN
MICRON
Tyco Electronics reserves the right to amend
this drawing at any time. Users should
evaluate the suitability of the product for
their application.
DCR NUMBER:
D010043
REPLACES:
N/A
DRAWN BY:
M. FORONDA
DATE:
15-Feb.-01
PROD. REV.
SEE TABLE
DOC ISSUE: SCALE:
1
None
SIZE:
A
SHEET:
5 of 7
If this document is printed it becomes uncontrolled. Check for the latest revision.