D-436-0110 Datasheet, PDF (2/2 Pages) PANDUIT CORP. – IN-LINE SPLICE SEALING SYSTEM, 2 or 3 to 1 SPLICE: TIN PLATED, COLOR CODED with Inspection Slots

SPECIFICATION CONTROL DRAWING
DEVICES ASSEMBLY PROCEDURE
1.0
SCOPE
This document oulines the procedure to be followed to obtain immersion resistant 3 or 2 to 1 in-line splices
using Devices In-line Splice Sealing System D-436-0110.
2.0
PROCEDURE
a. Strip all wires 6.35 to 7.92 (0.250 to 0.312).
b. Attach the single lead to the appropriate size crimp splicer using a Raychem AD-1377 crimp tool.
c. Pass the wires to be attached to the other barrel through the sealing sleeve from the three-hole insert end.
d. Insert wires into barrel and crimp. Care must be taken so that wires remain untwisted between the crimp
splicer and the three wire seal or the sealing sleeve cannot be positioned properly.
e. Apply heat, first to the three-hole insert and then to the other. Heat should be applied until insert melts
and flows axially along the wire.
Tyco Electronics Corporation
305 Constitution Drive
Menlo Park, CA 94025, USA
Raychem
Products
UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS.
INCHES DIMENSIONS ARE BETWEEN BRACKETS.
TOLERANCES:
0.00 N/A
0.0 N/A
0 N/A
ANGLES: N/A
ROUGHNESS IN
MICRON
Tyco Electronics reserves the right to amend this
drawing at any time. Users should evaluate the
suitability of the product for their application.
DRAWN BY:
M. FORONDA
REPLACES:
N/A
DCR NUMBER:
D001273
If this document is printed it becomes uncontrolled. Check for the latest revision.
TITLE :
IN-LINE SPLICE SEALING SYSTEM,
2 or 3 to 1 SPLICE: TIN PLATED,
COLOR CODED with Inspection Slots
DOCUMENT NO.: D-436-0110
DATE:
14-Nov.-00
DOC ISSUE:
1
PROD. REV. SCALE:
A
None
SIZE:
A
SHEET:
2 of 2