D-436-0110 Datasheet, PDF (1/2 Pages) PANDUIT CORP. – IN-LINE SPLICE SEALING SYSTEM, 2 or 3 to 1 SPLICE: TIN PLATED, COLOR CODED with Inspection Slots

SPECIFICATION CONTROL DRAWING
MATERIALS
1. INSULATION SLEEVE: Heat-shrinkable, transparent blue, radiation cross-linked modified polyvinylidene
fluoride.
2. SINGLE WIRE SEAL: Low outgassing immersion resistant thermoplastic.
3. THREE WIRE SEAL: Low outgassing immersion resistant thermoplastic.
4. CRIMP SPLICE: Base Metal: Copper Alloy 102 per ASTM B-75.
Plating: Tin, per MIL-T-10727, Type I
Size
20 - 26
Wire Size Range of Crimp Splice
One Wire
Two Wires
min
max
min
max
26
20
26
24
Three Wires
min
max
28
26
APPLICATION
1. These parts are designed to provide immersion resistant in-line splices of 2 or 3 to 1 wires falling within size range
listed above, and having insulations rated for 135°C.
2. Parts are available only as an assembly of one each item #I and item #II.
3. Parts are to be installed following Devices Assembly Procedure (see sheet 2 of 2).
4. Inside diameter and outside diameter of splicer are to be measured in crimp areas, 2.54 to 5.08 (0.100 to 0.200)
from ends of part. Slight burr permitted on parted surfaces.
5. Packing and packaging shall be accordance with Section 5, Level C, of MIL-T-7928.
6. This document takes precedence over documents referenced herein.
7. For other sizes of this configuration, see Devices specification Control Drawings D-436-42/-43.
Tyco Electronics Corporation
305 Constitution Drive
Menlo Park, CA 94025, USA
Raychem
Products
UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS.
INCHES DIMENSIONS ARE BETWEEN BRACKETS.
TOLERANCES:
0.00 N/A
0.0 N/A
0 N/A
ANGLES: N/A
ROUGHNESS IN
MICRON
Tyco Electronics reserves the right to amend this
drawing at any time. Users should evaluate the
suitability of the product for their application.
DRAWN BY:
M. FORONDA
REPLACES:
N/A
DCR NUMBER:
D001273
If this document is printed it becomes uncontrolled. Check for the latest revision.
TITLE :
IN-LINE SPLICE SEALING SYSTEM,
2 or 3 to 1 SPLICE: TIN PLATED,
COLOR CODED with Inspection Slots
DOCUMENT NO.: D-436-0110
DATE:
14-Nov.-00
DOC ISSUE:
1
PROD. REV. SCALE:
A
None
SIZE:
A
SHEET:
1 of 2