D-436-42 Datasheet, PDF (1/4 Pages) PANDUIT CORP. – IN-LINE SPLICE SEALING SYSTEM, MULTI-WIRE

SPECIFICATION CONTROL DRAWING
MATERIALS
1. INSULATION SLEEVE: Heat-shrinkable, transparent blue, radiation cross-linked modified polyvinylidene
flouride.
2. INTEGRAL MULTI-WIRE SEAL: Modified thermoplastic.
3. SEPARATE MULTI-WIRE SEAL: Modified thermoplastic.
4. CRIMP SPLICER: Base Metal: Copper Alloy 101 or 102 per ASTM B-75.
Plating: Tin per MIL-T-10727, Type 1.
Color Code: See table below.
Part
Name
D-436-42
D-436-43
Prod.
Rev.
F
A
Dimensions: Crimp Splice
I.D.±0.05 O.D.±0.08 Color
(I.D.±0.002) (O.D.±0.003) Code
1.70 (0.067) 2.62 (0.103) Blue
2.54 (0.100) 3.81 (0.150) Yellow
Installation Data: Wire Size Range of Crimp Splicer
Two Wires
Three Wires
Minimum Maximum Minimum Maximum
2 x 24
2 x 20
3 x 24
3 x 22
2 x 22
2 x 16
3 x 22
3 x 18
APPLICATION
1. These parts are designed to provide an immersion resistant in-line splices of 2 or 3 to 2 or 3 wires falling within
the size range listed above, having insulations rated for at least 135C.
2. Parts are available only as an assembly of one of each Item #1 and Item #2.
3. Crimp splicer may be installed with Raychem AD-1377 crimp tool or equivalent.
4. Inside diameter and outside diameter of splice are to be measured in crimp area, 2.54 to 5.08 (0.100 to 0.200)
from ends of part. Slight burr permitted on parted surfaces.
5. Acceptance sampling shall be in accordance with paragraph 4.6.1 of MIL-T-7928.
6 . Packing and packaging shall be in accordance with Section 5, Level C, of MIL-T-7928.
7. This document takes precedence over documents referenced herein.
1.0 TEST ASSEMBLIES
TE Connectivity
305 Constitution Drive
Menlo Park, CA 94025, USA
Raychem
Products
TITLE :
IN-LINE SPLICE SEALING
SYSTEM, MULTI-WIRE
UNLESS OTHERWISE SPECIFIED DIMENSIONS ARE IN MILLIMETERS.
INCHES DIMENSIONS ARE BETWEEN BRACKETS.
TOLERANCES:
0.00 N/A
0.0 N/A
0 N/A
ANGLES: N/A
ROUGHNESS IN
MICRON
TE Connectivity reserves the right to amend this
drawing at any time. Users should evaluate the
suitability of the product for their application.
DRAWN BY:
M. FORONDA
REPLACES:
N/A
DCR NUMBER:
D001303
If this document is printed it becomes uncontrolled. Check for the latest revision.
DOCUMENT NO.: D-436-42/-43
DATE:
15-Apr-11
DOC ISSUE:
2
PROD. REV.
SCALE: SIZE:
SEE TABLE None
A
SHEET:
1 of 4