CNZ1414A Datasheet, PDF (2/3 Pages) Panasonic Semiconductor – Integrated Photosensor

Integrated Photosensors
CNZ1414A
Electrical Characteristics (Ta = 25˚C)
Parameter
Input
Forward voltage (DC)
characteristics _{Reverse current (DC)}
“H” Output current
“L” Output voltage
Output
characteristics
Operating power voltage
“L” Supply current
“H” Supply current
Threshold input current
Transfer ^Hysteresis
characteristics
Response time
* _{Switching time measurement circuit}
Symbol
V_F
I_R
I_OH
V_OL
V_CC
I_CCL
I_CCH
I_FH→L
I_FLH/I_FHL
t_PHL*
t_PLH*
Conditions
I_F = 20mA
V_R = 3V
V_CC = 5V, V_OH = 12V, I_F = 0mA
V_CC = 5V, I_OL = 5mA, I_F = 2mA
V_CC = 5V, I_F = 2mA
V_CC = 5V, I_F = 0mA
V_CC = 2.2V
V_CC = 2.2V
V_CC = 5V, I_F = 2mA, R_L = 1kΩ
min typ max Unit
1.2 1.4 V
10 µA
100 µA
0.15 0.4 V
2.2
7
V
0.8
2
mA
0.8
2
mA
2 mA
0.85
3
µs
8
µs
Sig.IN
Const. Voltage Cir.
V_CC
R_L = 1kΩ
(Input pulse)
Sig.OUT _{(Output pulse)}
,, _,, ^50Ω
t_PHL t_PLH
50%
V_OH
1.5V
V_OL
t_PHL : H L Propagation time
t_PLH : L H Propagation time
Important Information for Soldering
1. Soldering Position
A
,,,,,, _{Soldering bath}
A : Make sure the distance is 0.1 mm or more.
2. Solder Temperature and Soldering Time
Temperature : 260˚C or less
Time : within 3 seconds
Note) Avoid using reflow soldering methods.
3. Other Issues
1) Soldering should not create excessive thermal or mechanical stress on the case package or leads.
Excessive stress may cause changes in the shape or characteristics of the package or leads.
2) Be careful not to allow solder, flux, solvents, etc. to remain on the case package.
Doing so may cause problems related to transmission characteristics, etc.
Important Information Related to Power Source Voltage
In order to stabilize the power line, use a decoupling capacitor of
approximately 0.1 µF between V_CC and the GND line near the device .
V_CC
V_O
GND
R_L
0.1µF
V_CC
V_O
GND
2