CNZ1413 Datasheet, PDF (2/3 Pages) Panasonic Semiconductor – Integrated Photosensors

CNZ1413
Integrated Photosensors
Electrical Characteristics (Ta = 25˚C)
Parameter
Symbol
Conditions
Input Forward voltage (DC)
V_F
I_F = 20mA
characteristics Reverse current (DC)
I_R
V_R = 3V
“H” Output current
I_OH
V_CC = 5V, V_OH = 30V, I_F = 0mA
Output “L” Output voltage
V_OL
V_CC = 5V, I_OL = 20mA, I_F = 5mA
characteristics Operating power voltage V_CC
Low-level supply current
I_CCL
V_CC = 5V, I_F = 5mA
High-level supply current
I_CCH
V_CC = 5V, I_F = 0mA
Threshold input current I_FH→L(I_FL→H) V_CC = 5V
Transfer Hysteresis
I_FLH/I_FHL(I_FHL/I_FLH) V_CC = 5V
characteristics
Response time
t_PHL(t_PLH)^* V_CC = 5V, I_F = 5mA, R_L = 1kΩ
t_PLH(t_PHL)^* V_CC = 5V, I_FP = 5mA, R_L = 1kΩ
Note) Normally ON type characteristics is shown, ( ) shows Normally OFF type.
* _{Switching time measurement circuit}
min typ max Unit
1.2 1.4 V
10 µA
100 µA
0.15 0.4 V
4.5 17 V
2.4 5 mA
0.8 3 mA
5 mA
0.7
2.5(3.5)
µs
6(5)
µs
Sig.IN
Const. Voltage Cir.
V_CC
R_L = 1kΩ
(Input pulse)
Sig.OUT _{(Output pulse)}
,, _,, ^50Ω
t_PHL t_PLH
50%
V_OH
1.5V
V_OL
t_PHL : H L Propagation time
t_PLH : L H Propagation time
Important Information for Soldering
1. Soldering Position
A
,,,,,, _{Soldering bath}
A : Make sure the distance is 0.1 mm or more.
2. Solder Temperature and Soldering Time
Temperature : 260˚C or less
Time : within 3 seconds
Note) Avoid using reflow soldering methods.
3. Other Issues
1) Soldering should not create excessive thermal or mechanical stress on the case package or leads.
Excessive stress may cause changes in the shape or characteristics of the package or leads.
2) Be careful not to allow solder, flux, solvents, etc. to remain on the case package.
Doing so may cause problems related to transmission characteristics, etc.
2