|
I38I Datasheet, PDF (6/7 Pages) P-tec Corporation – I38i T8 LED Tube | |||
|
◁ |
Wiring Diagram for Electronic Ballast
Before
CUT
CUT
After
ï¬ Retrofit Luminaire with Magnetic Ballast
Installation Steps
Repeat Steps 1 to 7 of âretrofit luminaires with electronic ballastâ excepting Step 3, changes in which are noted below:
Step 3: Cut the ballast output lead and cut the wirings of the starter. Both the ballast and starter need to remain in place. (For detailed
placement of the cuts, note the Xâs on the wiring diagram labeled âBeforeâ shown below.)
www.atgelectronics.com Toll free: 877-461-5333
|
▷ |