I38I Datasheet, PDF (5/7 Pages) P-tec Corporation – I38i T8 LED Tube

USER GUIDE
Included in this box
ATG Electronics iBright™ I38i T8 LED Tube (G3 IPS US), 1 Pc
User Guide, 1 set
Red-Black Wires, 2 PCs
Wire Nuts, 4 PCs
Note:
Please read this entire manual to fully understand and safety use this product.
Specifications are subject to change without notice. Please visit www.atgelectronics.com for the most recent user guide versions.
Warning：
WARNING – Risk of fire or electric shock. iBright™ I38i T8 LED Tube installation requires knowledge of luminaires electrical systems. If not
qualified, do not attempt installation. Contact a qualified electrician.
WARNING – Risk of fire or electric shock. Install this kit only in the luminaires that have the construction features and dimensions shown in the
photographs and/or drawings.
WARNING – To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Lamp replacement instructions shall indicate the manufacturer's custom lamp part number, and a method to order replacement lamps by
phone, website and/or mail. These instructions shall be included on an information sheet packaged with each unit.
 Retrofit Luminaire with Electronic Ballast
Installation Steps
Step 1:Turn off main power before installation.
For safety, make sure main power source is switched off before attempting to install.
Step 2:Take off existing fluorescent light and disconnect the ballast.
Step 3: Cut four leads of G13 lamp holders. (For detailed placement of the cuts, note the X’s on the wiring diagram labeled “Before” shown
below.)
Step 4: Reconnect lamp holder leads L and N to the supply wires of branch circuit according to the wiring diagram below. Both G13 sockets of
the fixture should be connected to the power source directly.
Step 5: Install fixture as before.
Step 6: Adhere a label to the luminaire to the effect of “This luminaire has been modified and can no longer operate fluorescent lamps.” on the
retrofitted luminaire, where readily visible during relamping.
Step 7: Install the iBright™ LED tube into the fixture.
Step 8: Turn on the power.
www.atgelectronics.com Toll free: 877-461-5333