HAE100_14 Datasheet, PDF (4/4 Pages) Power Mate Technology Co., LTD – HALF-BRICK DC-DC CONVERTER

MECHANICAL DRAWING
HAE100
1. All dimensions in inch (mm)
2. Tolerance :x.xx±0.02 (x.x±0.5)
x.xxx±0.01 (x.xx±0.25)
3. Pin pitch tolerance ±0.01 (0.25)
4. Pin dimension tolerance ±0.004(0.1)
5. Mounting screws should always be used.
6. The screw locked torque:
MAX 5.0kgf-cm(0.49N-m)
PIN CONNECTION
PIN
DEFINE
1
-Vin
2
Case
3
Ctrl
4
+Vin
5
-Vout
6
-Sense
7
Trim
8
+Sense
9
+Vout
DIAMETER
0.04 Inch
0.04 Inch
0.04 Inch
0.04 Inch
0.08 Inch
0.04 Inch
0.04 Inch
0.04 Inch
0.08 Inch
EXTERNAL OUTPUT TRIMMING
Output can be externally trimmed by using the
method shown below.
R_U
=
 ^{V OUT (100 + ∆ % )} −
 ^{1 .225 ∆ %}
(100 + 2 ∆ % ) _{k Ω}
∆%

R_D
=  ¹⁰⁰
 ^∆%
− 2 k Ω

HEAT-SINK TYPE OPTIONS
Vertical Fin Orientation, Suffix:-HS, -HS2
Horizontal Fin Orientation, Suffix:-HS1, -HS3
TERMINAL BLOCK TYPE OPTION
Wall mounted, Suffix: -T
HS: Height H=0.45” vertical fin,
7G-0021A-F
HS1: Height H=0.24” horizontal fin,
7G-0022A-F
HS2: Height H=0.24” vertical fin,
7G-0023A-F
HS3: Height H=0.45” horizontal fin,
7G-0024A-F
1. All dimensions in inch (mm)
2. Tolerance :x.xx±0.02 (x.x±0.5)
x.xxx±0.01 (x.xx±0.25)
Wall mounted with EMC Filter, Suffix: -TF
Wall mounted with EMC Filter, Suffix: -TF1
(Can be connected to PE )
Terminal block type
-T
-TF
Weight
200g (7.05oz)
280g (9.88oz)
Dimensions
Through hole (W×L)
3.35 x 2.40 x 1.10 inch (85.0 x 61.0 x 28 0mm) 3.35 x 2.40 x 1.47 inch (85.0 x 61.0 x 37.3 mm)
ψ ψ 2.126 x 3.071 inch (54.00 x 78.00 mm), 4- 0.17 inch ( 4.3mm)
For further information, please contact with P-DUKE.
-TF1
287g (10.12oz)
3.35 x 2.40 x 1.53 inch (85.0 x 61.0 x 38.8 mm)
4
www.PDUKE.com
2014/04/30