English
Language : 

SPS-6110WG Datasheet, PDF (2/7 Pages) Optoway Technology Inc – 16G FC / 1310 nm / 10 km Digital Diagnostic SFP LC SINGLE-MODE TRANSCEIVER
Optoway
2
SPS-6110WG
***********************************************************************************************************************************************************************
Transmitter Optical Specifications (0oC < Topr < 70oC, 3.13V < Vcc < 3.47V)
Parameter
Symbol
Min
Typ
Max
Units
Notes
Optical Modulation Amplitude
Po, OMA
-2
Average Launch Power
Po, Avg
-4
Extinction Ratio
ER
3.5
+2
dBm
+2
dBm
1
Output Center Wavelength
Output Spectrum Width
Side Mode Suppression Ratio
λc
σλ
SMSR
1295
30
1325
1
nm
nm -20 dB width
dB
Transmitter and Dispersion
TDP
Penalty
Relative Intensity Noise
RIN
4.4
dB
-130
dB/Hz
Average Launch Power of OFF
-30
dBm
Transmitter
1. Output power is power coupled into a 9/125 µm single-mode fiber.
Receiver Optical Specifications (0oC < Topr < 70oC, 3.13V < Vcc < 3.47V)
Parameter
Symbol
Min
Typ
Max
Units
Notes
Unstressed Sensitivity at 14.025
Sens
-12
dBm
2, OMA
Gb/s
-10.9
dBm
3, Average Power
Stress Sensitivity at 14.025 Gb/s
Sens
---
-10.2
dBm
2, OMA
Receiver Overload
LOS -- Deasserted
LOS -- Asserted
Wavelength of Operation
PMAX
LOSD
LOSA
λc
2
---
-22
1260
---
dBm
---
-12
dBm Transition: low to high
---
---
dBm Transition: high to low
1565
nm
Optical Return Loss
ORL
-12
dB
2. Measured with worst ER; BER < 10-12 and PRBS 231-1.
3. Represents sensitivity based on OMA spec, as corrected to incoming Extinction Ratio of 3.5 dB. For example, an OMA of 0.063 mW
(-12 dBm) is approximately equal to an average power of -10.9 dBm, average with an Extinction ratio of 3.5 dB.
Electrical Characteristics
Parameter
Symbol
Min
High-Speed Signal (CML) Interface Specification
Input Data Rate
4.25
TX Clock Tolerance
Differential Input Impedance
Rin
Differential Data Input Amplitude
150
Output Data Rate
4.25
RX Clock Tolerance
Differential Output Impedance
Rout
Differential Data Output
350
Amplitude
Low-Speed Signal (LVTTL) Interface Specification
Input High Voltage
2.0
Input Low Voltage
GND
Output High Voltage
2.4
Output Low Voltage
GND
4. Clock tolerance for 14.025 Gb/s, 8.5Gb/s and 4.25 Gb/s.
Typ
14.025
100
14.025
100
600
Max
±100
1200
±100
700
Units
Notes
Gb/s
ppm
Ω
mVpp
Gb/s
ppm
Ω
mVpp
4
Internally AC coupled
4
Internally AC coupled
Vcc+0.3
V
0.8
V
Vcc
V
0.5
V
**********************************************************************************************************************************************************************
OPTOWAY TECHNOLOGY INC. No.38, Kuang Fu S. Road, Hu Kou, Hsin Chu Industrial Park, Hsin Chu, Taiwan 303
Tel: 886-3-5979798
Fax: 886-3-5979737
E-mail: sales@optoway.com.tw http: // www.optoway.com.tw 2011/7/1 V1.0