OSXX0402C1C_VER.A.1 Datasheet, PDF (4/7 Pages) OptoSupply International – 1.0x0.5x0.4mm smd

1.0 x 0.5 x 0.4mm SMD
OSXX0402C1C
Ver.a.1
3) Manual Soldering conditions.
- Lead Solder
℃ Max. 300 for Max. 3sec, and only one time.
- Lead-free Solder
℃ Max. 350 for Max. 3sec, and only one time.
- There is possibility that the brightness of LEDs is decreased, which is influenced by heat or ambient
atmosphere during reflow. It is recommended to use the nitrogen reflow method.
- After LEDs have been soldered, repair should not be done. As repair is unavoidable, a double-head
soldering iron should be used. It should be confirmed beforehand whether the characteristics of the
LEDs will be damaged by repairing or not.
- Reflow soldering should not be done more than two times.
LED & Application Technologies