OVFSAAC8 Datasheet, PDF (2/5 Pages) OPTEK Technologies – 4-Pin Amber LED Lamp (7.6mm)

4-Pin Amber LED Lamp (7.6mm)
OVFSAAC8
Absolute Maximum Ratings
T_A = 25^o C unless otherwise noted
Storage Temperature Range
-40 ~ +100°C
Operating Temperature Range
Lead Soldering Temperature (3mm from the base of the epoxy bulb)¹
-40 ~ +100°C
260°C
Reverse Voltage
5V
Continuous Forward Current²
70 mA
Peak Forward Current (10% Duty Cycle, PW ”  —VHF
200 mA
Power Dissipation
210 mW
Notes:
1. Solder time less than 5 seconds at temperature extreme.
2. Heat sink is adequate if the device is operated at ambient temperature higher than 25°C. For long term performance the drive currents
between 10mA and 50mA are recommended. Please contact an Optek sales representative for more information on recommended drive
conditions.
Electrical Characteristics
T_A = 25^o C unless otherwise noted
SYMBOL
PARAMETER
MIN
TYP
MAX UNITS
CONDITIONS
lumen
V_F
Luminous Flux
Forward Voltage
3000
5000
----
mlm
----
2.5
3.0
V
I_F = 70mA
I_F = 70mA
I_R
Reverse Current
----
----
100
µA
V_R = 5V
D
Dominant Wavelength
584
591
599
nm
I_F = 70mA
2½
50% Power Angle
----
100
----
deg
I_F = 70mA
Standard Bins (I_F = 70mA)
Lamps are sorted to luminous flux ( _V), forward voltage (V_F), and dominant wavelength ( _D) bins shown.
Orders for OVFSAAC8 may be filled with any or all bins contained as below.
X2
X3
X4
X5
X6
5000-7300
M
4000-6100
L
3500-4800
K
3000-4200
584
587
590
593 596
Dominant Wavelength (nm)
J
599
Luminous flux is at
J bin or above.
Forward Voltage (V_F)
Rank
V3
Voltage (V)
2.0–2.2
V4
2.2–2.4
V5
2.4–2.6
V6
2.6–2.8
V7
2.8–3.0
Important Notes:
1. All ranks will be included per delivery, rank ratio will be based on the chip distribution.
2. To designate luminous intensity ranks, please contact OPTEK.
Issue 1.0 0505
Page 2
OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006
Phone: [phone] or [phone] FAX: [phone] [e-mail] www.optekinc.com