OP265WPS Datasheet, PDF (2/3 Pages) OPTEK Technologies – Plastic Infrared Emitting Diode

Plastic Infrared Emitting Diode
OP265WPS
Absolute Maximum Ratings (T_A = 25° C unless otherwise noted)
Storage and Operating Temperature Range
Reverse Voltage
Continuous Forward Current
Peak Forward Current (1 µs pulse width, 300 pps)
Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 seconds with soldering iron]
Power Dissipation
-40^o C to +100^o C
2.0 V
50 mA
3.0 A
260° C⁽¹⁾
100 mW⁽²⁾
Notes:
1. RMA flux is recommended. Duration can be extended to 10 second maximum when flow soldering. A maximum of 20 grams force
may be applied to the leads when soldering.
2. Derate linearly at 1.33 mW/° C above 25° C.
3. E_E(APT) is a measurement of the average apertured radiant incidence upon a sensing area 0.081” (2.06 mm) in diameter, perpendicular
to and centered on the mechanical axis of the lens and 0.590” (14.99 mm) from the measurement surface. E_E(APT) is not necessarily
uniform within the measured area.
Electrical Characteristics (T_A = 25° C unless otherwise noted)
SYMBOL
PARAMETER
MIN TYP MAX UNITS
TEST CONDITIONS
Input Diode
E_{E (APT)}
V_F
I_R
λ_P
B
Apertured Radiant Incidence
Forward Voltage
Reverse Current
Wavelength at Peak Emission
Spectral Bandwidth between Half Power
Points
2.70 -
- mW/cm² I_F = 20 mA⁽³⁾
-
-
1.80
V I_F = 20 mA
-
-
20
µA V_R= 2 V
- 850 -
nm I_F = 10 mA
-
-
-
nm I_F = 20 mA
OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.
Issue A 07/06
Page 2 of 3
OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006
Phone: [phone] or [phone]
FAX: [phone] [e-mail] www.optekinc.com