OP265AA Datasheet, PDF (2/3 Pages) OPTEK Technologies – Plastic Infrared Emitting Diode

Plastic Infrared Emitting Diode
OP265AA Series
Absolute Maximum Ratings (T_A=25°C unless otherwise noted)
Storage and Operating Temperature Range
-40^o C to +100^o C
Reverse Voltage
2.0 V
Continuous Forward Current
50 mA
Peak Forward Current (1 µs pulse width, 300 pps)
Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 seconds with soldering iron]
Power Dissipation
3.0 A
260° C⁽¹⁾
100 mW⁽²⁾
Notes:
1. RMA flux is recommended. Duration can be extended to 10 second maximum when flow soldering. A maximum of 20 grams force
may be applied to the leads when soldering.
2. Derate linearly at 1.33 mW/° C above 25° C.
3. E_E(APT) is a measurement of the average apertured radiant incidence upon a sensing area 0.081” (2.06 mm) in diameter, perpendicular
to and centered on the mechanical axis of the lens and 0.590” (14.99 mm) from the measurement surface. E_E(APT) is not necessarily
uniform within the measured area.
Electrical Characteristics (T_A = 25°C unless otherwise noted)
SYMBOL
PARAMETER
MIN TYP MAX UNITS
TEST CONDITIONS
Input Diode
E_{E (APT)}
Apertured Radiant Incidence
OP265AA
OP265AB
OP265AC
OP265AD
5.50 -
7.50 -
11.50 -
15.50 -
-
12.5
16.5
-
I_F = 20 mA
mW/cm²
Aperture = 0.081” diameter
Distance = 0.590” from seating
surface to aperture surface
V_F
I_R
λ_P
∆λ_P /∆T
θ_HP
Forward Voltage
Reverse Current
Wavelength at Peak Emission
Spectral Shift with Temperature
Emission Angle at Half Power Points
-
-
1.80
V I_F = 20 mA
-
10
-
µA V_R= 10 V
- 850 -
nm I_F = 10 mA
- ±0.18 - nm/°C I_F = Constant
-
18
- Degree I_F = 20 mA
t_r
Output Rise Time
-
10
-
ns I_F(PK)=100 mA, PW=10 µs, D.C.=10.0%
t_f
Output Fall Time
-
10
-
ns
OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.
Issue A 07/06
Page 2 of 3
OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006
Phone: [phone] or [phone]
FAX: [phone] [e-mail] www.optekinc.com