OP240_14 Datasheet, PDF (2/3 Pages) OPTEK Technologies – Plastic Infrared Emitting Diode

Plastic Infrared Emitting Diode
OP240 Series
OP245 Series
OP245 (A, B, C, D)
1
Pin # LED
1 Cathode
2 Anode
2
CONTAINS POLYSULFONE
To avoid stress cracking, we suggest using
ND Industries’ Vibra-Tite for thread-locking.
Vibra-Tite evaporates fast without causing structural
failure in OPTEK'S molded plastics.
DIMENSIONS ARE IN:
[MILLIMETERS]
INCHES
Absolute Maximum Ratings (T_A=25°C unless otherwise noted)
Storage and Operating Temperature Range
-40^o C to +100^o C
Reverse Voltage
2.0 V
Continuous Forward Current
50 mA
Peak Forward Current
Lead Soldering Temperature [1/16 inch (1.6 mm) from case for 5 seconds with soldering iron]
Power Dissipation
3.0 A
260° C⁽¹⁾
100 mW⁽²⁾
Electrical Characteristics (T_A = 25°C unless otherwise noted)
SYMBOL
PARAMETER
MIN TYP MAX UNITS
TEST CONDITIONS
Input Diode
E_{E (APT)}
Apertured Radiant Incidence
OP240A, OP245A
OP240B, OP245B
OP240C, OP245C
OP240D, OP245D
0.60 -
-
0.40
-
1.20 mW/cm² I_F = 20 mA⁽³⁾
0.20 - 0.86
0.05 -
-
V_F Forward Voltage
I_R
Reverse Current
λ_P
Wavelength at Peak Emission
B
Spectral Bandwidth between Half Power
Points
-
-
1.80
V I_F = 20 mA
-
- 100 µA V_R= 2.0 V
- 890 -
nm I_F = 10 mA
-
80
-
nm I_F = 10 mA
∆λ_P /∆T
θ_HP
t_r
t_f
Spectral Shift with Temperature
Emission Angle at Half Power Points
Output Rise Time
Output Fall Time
- ±0.18 - nm/°C I_F = Constant
-
40
- Degree I_F = 20 mA
- 500 -
- 250 -
ns _{IF(PK)=100 mA, PW=10 µs, and}
ns ^D.C.=10.0%
Notes:
1. RMA flux is recommended. Duration can be extended to 10 seconds maximum when flow soldering. A maximum of 20 grams force
may be applied to the leads when soldering.
2. Derate linearly 1.33 mW/° C above 25° C.
3. E_E(APT) is a measurement of the average apertured radiant energy incident upon a sensing area 0.180” (4.57 mm) in diameter
perpendicular to and centered on the mechanical axis of the lens and 0.653” (6.60 mm) from the lens tip. E_E(APT) is not necessarily
uniform within the measured area.
OPTEK reserves the right to make changes at any time in order to improve design and to supply the best product possible.
Issue A.1 01/07
Page 2 of 3
OPTEK Technology Inc. — 1645 Wallace Drive, Carrollton, Texas 75006
Phone: [phone] or [phone]
FAX: [phone] [e-mail] www.optekinc.com