OP910W Datasheet, PDF (1/2 Pages) OPTEK Technologies – PIN Silicon Photodiode

Product Bulletin OP910W
December 1998
PIN Silicon Photodiode
Type OP910W
Features
• Wide receiving angle
•Fast switching time
•Linear response vs. irradiance
•Enhanced temperature range
Description
The OP910W consists of a PIN silicon
photodiode mounted in a two-leaded
hermetic TO-46 package. The flat lens
has an acceptance half angle of ±40^o.
Dimensions are in inches (millimeters).
Absolute Maximum Ratings (TA = 25^oC unless otherwise noted)
Reverse Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60 V
Storage Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -65^o C to +150^o C
Operating Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . -65^o C to +125^o C
Lead Soldering Temperature [1/16 inch (1.6mm) from case for 5 sec. with soldering
iron] . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200^oC⁽¹⁾
Power Dissipation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 250 mW
Notes:
(1) RMA Flux is recommended. Duration can be extended to 10 sec. max. when flow
soldering.
(2) Light source is an unfiltered GaAs LED with a peak wavelength of 935 nm and a radiometric
intensity level which varies less than 10% over the entire lens surface of the photodiode
being tested.
(3) Junction temperature maintained at 25^o C.
(4)
To calculate typical dark current
ambient temperature in ^o C.
in
nA,
use
the
formula
ID=10^(0.42
T -1.5)
A
where
TA
is
(5) Derate linearly 2.5 mW/^o C above 25^o C.
Typical Performance Curves
Typical Spectral Response
Optek Technology, Inc.
1215 W. Crosby Road
Wavelength - nm
Carrollton, Texas 75006
21
[phone]
Fax [phone]