OP604ESA-XN Datasheet, PDF (1/2 Pages) OPTEK Technologies – High Reliability NPN Silicon Phototransistor

Product Bulletin OP604ESA
September 1996
High Reliability NPN Silicon Phototransistor
Type OP604ESA-XN⁽³⁾
Features
• Processed to Optek’s Space level
screening program patterned after
FSA/SCC Generic Specification 5000
• Miniature hermetically sealed package
• Ideal for direct mounting in PC boards
• Mechanically and spectrally matched
to the OP224 Series LED
Description
The OP604ESA consists of a high
reliability NPN silicon phototransistor
mounted in a miniature glass lensed,
hermetically sealed, “pill”package.
All devices are processed to Optek’s
program patterned after ESA/SCC
Generic Specification No. 5000. See
page 13-4 for details. This device type is
lensed and has an acceptance half angle
of 18^o measured from the optical axis to
the half power point. The series is also
mechanically and spectrally matched to
Optek’s OP224 series high reliability
infrared emitting diode.
Absolute Maximum Ratings (T_A = 25^o C unless otherwise noted)
Storage Temperature Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -65^o C to +150^o C
Operating Temperature Range. . . . . . . . . . . . . . . . . . . . . . . . . . . . -55^o C to +125^o C
Collector-Emitter Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 V
Emitter-Collector Voltage. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7.0 V
Soldering Temperature (for 5 seconds with soldering iron) . . . . . . . . . . . . . 240^o C⁽¹⁾
Power Dissipation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 50 mW⁽²⁾
Notes:
(1) No-clean or low solids RMA flux is recommended. Duration can be extended to 10 seconds
maximum when wave soldering.
(2) Derate linearly 0.5 mW/^o C above 25^o C.
(3) “X”defines the testing level per ESA/SCC Generic Specification 5000, Chart III. “X”will be
either “B”(full processing) or “C”(reduced processing).
“N”defines lot acceptance testing. “N”will be either 1, 2, or 3. Level 3 is the lowest defined
level with emphasis on electrical tests, solderability, and visual inspection. Level 2 requires
all tests of Level 3 and adds indurance testing (burn-in) with drift limits on key parameters.
Level 1 is the most stringent LAT level and includes all requirements of Levels 2 and 3 plus
additional testing for tolerance of thermal, mechanical, and environmental exposure.
Optek
High Reliability
Part Number Guide
OP604ESA-XN
ESA/SCC Specification
No. 5000
“B”- Full Processing
“C”- Reduced Processing
Level ”1”
Environmental/Mechanical
plus 2 & 3
Level “2”Life Testing plus
Level 3
Level “3" Electrical
Inspection
Optek Technology, Inc.
1215 W. Crosby Road
Carrollton, Texas 75006
13-32
[phone]
Fax [phone]