CS1088 Datasheet, PDF (6/8 Pages) ON Semiconductor – Vacuum Fluorescent Display Tube Driver

CS1088
APPLICATION INFORMATION
Table 1. Bit Pattern, G = Grid, A = Anode.
Bit #
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17
Pin Name G1 G2 G3 A1 A2 A3 A4 A5 A6 A7 A8 A9 A10 A11 A12 A13 A14
Bit #
18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34
Pin Name A15 A16 A17 A18 A19 A20 A21 A22 A23 A24 A25 A26 A27 A28 A29 A30 A31
CLK_IN
D_IN
1
2
3
4
5
6
7
8
9
BIT 1 BIT 2 BIT 3 BIT 4 BIT 5 BIT 6 BIT 7 BIT 8 BIT 9
32
33
34
1
2
3
BIT 32 BIT 33 BIT 34 BIT 1 BIT 2 BIT 3
STB
ANODES
GREN
GRIDS *
* Selected grid goes high only if input bit pattern from shift register to grid is high.
Figure 3. Typical Operation
Unused grid and anode drivers should have their
respective bits set to logic low in the data stream.
Multiple grid or anode drivers may be connected together,
but must be programmed to the same logic state for proper
device operation. Maximum package power must be
observed and care must be taken to maintian junction
temperature below +150°C.
http://onsemi.com
6