STK534U362C-E Datasheet, PDF (3/15 Pages) ON Semiconductor – Intelligent Power Module (IPM)

STK534U362C-E
Electrical Characteristics at Tc = 25C, VD1, VD2, VD3, VD4 = 15 V, VCC = 300 V, L = 3.9 mH
Parameter
Symbol
Conditions
Test
circuit
MIN
TYP MAX
Unit
Switching Character
Switching time
Turn-on switching loss
Turn-off switching loss
Total switching loss
Turn-on switching loss
Turn-off switching loss
Total switching loss
Diode reverse recovery energy
Diode reverse recovery time
Reverse bias safe operating area
Short circuit safe operating area
Allowable offset voltage slew rate
t ON
t OFF
Eon
Eoff
Etot
Eon
Eoff
Etot
Erec
Trr
RBSOA
SCSOA
dv/dt
Io = 10 A
Io = 5 A
Io = 5 A, Tc = 100C
I_F = 5 A, P = 400 V, L = 0.5 mH,
Tc = 100C
Io = 20 A, VCE = 450 V
VCE = 400 V, Tc = 100C
Between U,V,W to
U-,V-,W-
Reference voltage is “VSS” terminal voltage unless otherwise specified.
Fig.5
Fig.5
Fig.5
-
-
-
-
-
0.3
0.5
1.2
-
1.5
2.0
-
240
-
-
120
-
-
360
-
-
270
-
-
160
-
-
430
-
-
17
-
-
62
-
Full square-
4
-
-
50
-
50
μs
μJ
μJ
μJ
μJ
μJ
μJ
μJ
ns
μs
V/ns
Product parametric performance is indicated in the Electrical Characteristics for the listed test conditions, unless otherwise noted. Product performance may not be
indicated by the Electrical Characteristics if operated under different conditions.
Notes
1. When the internal protection circuit operates, a Fault signal is turned ON (When the Fault terminal is low level, Fault signal
is ON state : output form is open DRAIN) but the Fault signal does not latch.After protection operation ends,it returns
automatically within about typ. 2 ms and resumes operation beginning condition. So, after Fault signal detection, set all
input signals to OFF (Low) at once. However, the operation of pre-drive power supply low voltage protection (UVLO:with
hysteresis about 0.2 V) is as follows.
Upper side:
The gate is turned off and will return to regular operation when recovering to the normal voltage, but the latch will continue
till the input signal will turn ‘low’.
Lower side:
The gate is turned off and will automatically reset when recovering to normal voltage. It does not depend on input signal
voltage.
2. When assembling the IPM on the heat sink with M3 type screw, tightening torque range is 0.6 Nm to 0.9 Nm.
3. When use the over-current protection with external resistor, please set resistance value so that current protection value
becomes equal to or less than the double (2 times) of the rating output electric current (Io).
www.onsemi.com
3