KAI-16070 Datasheet, PDF (29/48 Pages) ON Semiconductor – Interline CCD Image Sensor

KAI−16070
Using the Electronic Shutter
This flow chart applies to both the full and 1/4 resolution
modes. The exposure time begins on the falling edge of the
electronic shutter pulse on the SUB pin. The exposure time
ends on the falling edge of the +13 V to 0 V transition of the
V1T and V1B pins. NEXP is varied to change the exposure
time in increments of the line time. The electronic shutter
timing is obtained from Figure 32.
Frame Timing
(see Table 21)
Line Timing
(see Table 22)
Pixel Timing
(see Table 23)
Repeat NH
Times
Repeat NV−NEXP
Times
Electronic
Shutter Timing
Line Timing
(see Table 22)
Pixel Timing
(see Table 23)
Repeat NH
Times
Repeat NEXP
Times
NOTE: NEXP: Exposure time in increments of number of lines.
Figure 24. Timing Flow Chart using the Electronic Shutter for Exposure Control
www.onsemi.com
29