LB11660RV Datasheet, PDF (2/9 Pages) Sanyo Semicon Device – Single-Phase Full-Wave Driver

LB11660RV
Absolute Maximum Ratings at Ta = 25C
Parameter
VCC maximum power supply voltage
VM maximum power supply voltage
OUT pin maximum output current
OUT pin output withstand voltage 1
OUT pin output withstand voltage 2
PRE pin maximum source current
PRE pin maximum sink current
PRE pin output withstand voltage
HB maximum output current
VTH input pin withstand voltage
RD output pin output withstand voltage
RD output current
Allowable power dissipation
Operating temperature range
Storage temperature range
Symbol
VCC max
VM max
IOUT max
VOUT max1
VOUT max2
IPSO max
IPSI max
VP max
HB
VTH max
VRD max
IRD max
Pd max
Topr
Tstg
Conditions
Rf0.39
T0.4s
Mounted on a specified board *1
*2
*1 A circuit board for mounting (114.3mm76.1mm1.6mm, glass epoxy resin)
*2 Tj max = 150 C. Must be used within the operating temperature range in which Tj does not exceed 150 C.
Ratings
Unit
20
V
20
V
1.5
A
20
V
26.5
V
30
mA
7
mA
20
V
10
mA
7
V
18
V
10
mA
0.8
W
30 to 95
C
55 to 150
C
Stresses exceeding those listed in the Maximum Ratings table may damage the device. If any of these limits are exceeded, device functionality should not be assumed,
damage may occur and reliability may be affected.
Recommended Operating Range at Ta = 25C
Parameter
VCC power supply voltage
VM power supply voltage
Current limiter operating range
VTH input level voltage range
Hall input common phase input voltage range
Symbol
VCC
VCC
ILIM
VTH
VICM
Conditions
Ratings
Unit
4 to 15
V
3 to 15
V
0.6 to 1.2
A
0 to 6
V
0.2 to 3
V
Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond the Recommended
Operating Ranges limits may affect device reliability.
www.onsemi.com
2