CSPEMI201AG_11 Datasheet, PDF (2/5 Pages) ON Semiconductor – 2 Channel Headset Speaker EMI Filter

CSPEMI201AG
Table 1. PIN DESCRIPTIONS
5−bump CSP Package
Pin
Name
Description
A1 SPKR_IN1 Speaker Input 1 (from audio circuitry)
A3 SPKR_IN2 Speaker Input 2 (from audio circuitry)
B2
GND
Device Ground
C1 SPKR_OUT1 Speaker Output 1 (to speaker)
C3 SPKR_OUT1 Speaker Output 2 (to speaker)
PACKAGE / PINOUT DIAGRAMS
Top View
(Bumps Down View)
Orientation
Marking
123
+
A
B
C
Bottom View
(Pins Up View)
Pin “A1”
Marking
C1 C3
B2
A1
A1 A3
SPECIFICATIONS
CSPEMI201A
CSP Package
Table 2. ABSOLUTE MAXIMUM RATINGS
Parameter
Rating
Units
Storage Temperature Range
−65 to +150
°C
DC Power per Resistor
100
mW
DC Package Power Rating
200
mW
Stresses exceeding Maximum Ratings may damage the device. Maximum Ratings are stress ratings only. Functional operation above the
Recommended Operating Conditions is not implied. Extended exposure to stresses above the Recommended Operating Conditions may affect
device reliability.
Table 3. STANDARD OPERATING CONDITIONS
Parameter
Operating Temperature Range
Rating
−40 to +85
Units
°C
Table 4. ELECTRICAL OPERATING CHARACTERISTICS (Note 1)
Symbol
Parameter
Conditions
Min Typ Max Units
R
Resistance
9
10
11
W
C
Capacitance
80 100 120
pF
I_LEAK
V_SIG
Diode Leakage Current
Signal Voltage
Positive Clamp
Negative Clamp
V_IN = 5.0 V
I_LOAD = 10 mA
1.0
mA
V
5
7
15
−15 −10 −5
V_ESD
In−system ESD Withstand Voltage
(Note 2)
a) Human Body Model, MIL−STD−883, Method 3015
b) Contact Discharge per IEC 61000−4−2 Level 4
kV
±15
±8
V_CL Clamping Voltage during ESD Discharge
MIL−STD−883 (Method 3015), 8 kV
Positive Transients
Negative Transients
(Notes 2 and 3)
V
+15
−19
f_C
Cut−off frequency
Z_SOURCE = 50 W, Z_LOAD = 50 W
R = 10 W, C = 100 pF
31
MHz
1. T_A = 25°C unless otherwise specified.
2. ESD applied to input and output pins with respect to GND, one at a time.
3. Clamping voltage is measured at the opposite side of the EMI filter to the ESD pin. For example, if ESD is applied to Pin A1, then clamping
voltage is measured at Pin C1.
http://onsemi.com
2