LC87F1A32A Datasheet, PDF (18/26 Pages) Sanyo Semicon Device – CMOS IC FROM 32K byte, RAM 2048K byte on-chip 8-bit 1-chip Microcontroller with Full-Speed USB

LC87F1A32A
Continued from preceding page.
Parameter
Symbol
Pin/
Remarks
Conditions
VDD[V]
min
Output delay time tdD0(5)
SO4(P22), • Must be specified with
SI4(P23)
respect to rising edge of
SIOCLK.
• Must be specified as the time
to the beginning of output state
2.7 to 5.5
change in open drain output
mode.
• See Fig.8.
Specification
typ
max
unit
(1/3)tCYC
+0.05
s
Pulse Input Conditions at Ta = 30°C to +70°C, VSS1 = VSS2 = VSS3 = 0V
Parameter
High/low level
pulse width
Symbol
tP1H(1)
tP1L(1)
Pin/Remarks
INT0(P70),
INT1(P71),
INT2(P72),
INT4(P20 to P23),
INT5(P24 to P27)
Conditions
• Interrupt source flag can be set.
• Event inputs for timer 0 or 1 are
enabled.
VDD[V]
2.7 to 5.5
Specification
min
typ
max
unit
1
tPIH(2)
INT3(P73) when
• Interrupt source flag can be set.
tPIL(2)
noise filter time
• Event inputs for timer 0 are
2.7 to 5.5
2
constant is 1/1
enabled.
tCYC
tPIH(3)
INT3(P73) when
• Interrupt source flag can be set.
tPIL(3)
noise filter time
• Event inputs for timer 0 are
2.7 to 5.5
64
constant is 1/32
enabled.
tPIH(4)
INT3(P73) when
• Interrupt source flag can be set.
tPIL(4)
noise filter time
• Event inputs for timer 0 are
2.7 to 5.5
256
constant is 1/128
enabled.
tPIL(5)
RMIN(P73)
Recognized by the infrared
remote controller receiver circuit
as a signal.
2.7 to 5.5
4
RMC
K
(Note 5-
1)
tPIL(6)
RES
Resetting is enabled.
2.7 to 5.5
200
s
Note5-1: Represents the period of the reference clock (1 tCYC to 128 tCYC or the source frequency of the subclock)
for the infrared remote controller receiver circuit.
No.A0704-18/26