ULPMC10 Datasheet, PDF (13/19 Pages) ON Semiconductor – Struix System-in-Package

ULPMC10
Table 5. RECOMMENDED OPERATING CONDITIONS
Parameter
Symbol
Min
Typ
Max
Units
Power Supply Applied to VDD (Note 1)
VDD
1.8
3.3
3.5
V
Internal Oscillator Clock Frequency
1
20
MHz
Externally−Supplied Clock Frequency
40
MHz
Ambient Operating Temperature Range
Ta
−40
85
_C
Junction Temperature Range
Tj
75
_C
Functional operation above the stresses listed in the Recommended Operating Ranges is not implied. Extended exposure to stresses beyond
the Recommended Operating Ranges limits may affect device reliability.
1. Operation with Flash Read to down 1.3 V supported. For Flash Write a minimum VDD of 1.8 V required.
Table 6. ESD AND LATCH−UP CHARACTERISTICS
Parameter
ESD – Human Body Model
ESD – Charged Device Model
ESD – Machine Model
Latch*Up
Conditions
JEDEC JS*001*2010, all pins
JESD22*C101*E, all pins
JESE22*A115*C, all pins
JEDEC STD*78, all pins
Max
2000
750
250
± 100
Units
V
V
V
mA
ELECTRICAL CHARACTERISTICS
Typical Values
Unless otherwise noted, Typ values specify the typical
values based on design and characterization data under
normal operating conditions. Normal operating conditions
include a supply voltage (VDD) of 3.3 V and an operating
temperature of 25°C. For specific blocks, the details of the
normal operation conditions are described in their
respective sections.
Minimum and Maximum Values
Unless otherwise noted, Min and Max values specify the
designed range or measurement range and are guaranteed by
design and/or characterization.
Min and Max values specified may be based on factory
production test limits, design, or characterization data.
Normal Operating Conditions
Unless otherwise noted, normal operating conditions
indicate an ambient temperature Ta = 25°C and a supply
voltage VDD = 3.3 V. VDDD and VDDA and the Internal
Oscillator (PLL) are calibrated to their preset factory
calibration settings and correspond to their respective Typ
values. VDDO are powered externally from the VDDD
Digital Supply Regulator. No external loads are applied to
digital I/O or analog pins.
www.onsemi.com
13