NOIM1SM9600A Datasheet, PDF (1/66 Pages) ON Semiconductor – MANO 9600 9.6 MegaPixel Rolling Shutter CMOS Image Sensor

NOIM1SM9600A,
NOIM2SM9600A
Advance Information
MANO 9600 9.6 MegaPixel
Rolling Shutter CMOS
Image Sensor
http://onsemi.com
Features
• 9.6 MegaPixel Resolution in 3840 × 2500 Format
• 2.4 mm × 2.4 mm Square Pixels (Shared 4T Pixel Architecture)
• 2/3 inch Optical Format
• Monochrome (SM) Version
• 20 Frames per Second (fps) at Full Resolution
• 200 mW / 500 mW Power Consumption at 5 fps / 20 fps
• Four Low−Voltage Differential Signaling (LVDS) High Speed Serial
Outputs or One 10−bit CMOS Output
• On-chip 10-bit Analog-to-Digital Converter (ADC)
• Windowing to Attain Higher Frame Rate
• Rolling Shutter
• On-chip Fixed Pattern Noise (FPN) Correction
• Serial Peripheral Interface (SPI)
• Automatic Exposure Control (AEC)
• Phase Locked Loop (PLL)
• High Dynamic Range (HDR)
Figure 1. MANO 9600 Package Photograph
• Dual Power Supply (1.8 V and 3.3 V)
• 0°C to 70°C Operational Temperature Range
• 52-pin LCC
• 500 mW Power Dissipation (LVDS)
• 200 mW Power Dissipation (CMOS)
• These Devices are Pb−Free and are RoHS Compliant
Applications
• Biometrics (Fingerprinting)
• Machine Vision
• Inspection
• Microscopy
Description
The MANO9600 is a rolling shutter CMOS image sensor with a resolution of 3840 x 2500 pixels.
The high sensitivity 2.4 mm x 2.4 mm pixels supports correlated double sampling readout reducing noise and increasing
dynamic range.
A high level of programmability using a four wire serial peripheral interface enables the user to read out specific regions
of interest.
Higher frame rates are achieved with region of interest or sub−sampled readout modes. The sensor has built−in features for
bias control and power supply regulation.
The sensor has on−chip programmable gain amplifiers and 10−bit A/D converters. The integration time and gain parameters
can be reconfigured without any visible image artifact. Optionally the on−chip automatic exposure control loop (AEC) controls
these parameters dynamically. The image’s black level is either calibrated automatically or can be adjusted by adding a user
programmable offset.
The image data interface of the M1−SM part consists of four LVDS lanes running at 620 Mbps, facilitating frame rates up
to 20 frames per second. A separate synchronization and clock channel containing payload information is provided to facilitate
the image reconstruction at the receive end. The M2−SM part provides a parallel CMOS output interface at reduced frame rate
of 5 frames per second.
The MANO 9600 is packaged in a 52−pin LCC package and is available in a monochrome without micro lens.
Contact your local ON Semiconductor office for more information.
This document contains information on a new product. Specifications and information herein are subject to change without notice.
© Semiconductor Components Industries, LLC, 2014
1
February, 2014 − Rev. P0
Publication Order Number:
NOIM1SM9600A/D