NCP1612A Datasheet, PDF (1/33 Pages) ON Semiconductor – Enhanced, High‐Efficiency Power Factor Controller

NCP1612A, NCP1612B,
NCP1612A1, NCP1612A2,
NCP1612A3, NCP1612B2
Enhanced, High‐Efficiency
Power Factor Controller
The NCP1612 is designed to drive PFC boost stages based on an
innovative Current Controlled Frequency Fold−back (CCFF)
method. In this mode, the circuit classically operates in Critical
conduction Mode (CrM) when the inductor current exceeds a
programmable value. When the current is below this preset level, the
NCP1612 linearly decays the frequency down to about 20 kHz when
the current is null. CCFF maximizes the efficiency at both nominal
and light load. In particular, the stand-by losses are reduced to a
minimum.
Like in FCCrM controllers, an internal circuitry allows near-unity
power factor even when the switching frequency is reduced. Housed in
a SO−10 package, the circuit also incorporates the features necessary
for robust and compact PFC stages, with few external components.
General Features
• Near-unity Power Factor
• Critical Conduction Mode (CrM)
• Current Controlled Frequency Fold-back (CCFF): Low Frequency
Operation is Forced at Low Current Levels
• On-time Modulation to Maintain a Proper Current Shaping in CCFF
Mode
• Skip Mode Near the Line Zero Crossing
• Fast Line/Load Transient Compensation
(Dynamic Response Enhancer)
• Valley Turn On
• High Drive Capability: −500 mA/+800 mA
• V_CC Range: from 9.5 V to 35 V
• Low Start-up Consumption
• Six Versions: NCP1612A, B, A1, A2, A3 and B2 (see Table 1)
• Line Range Detection
• pfcOK Signal
• This is a Pb-Free Device
www.onsemi.com
SOIC−10
CASE 751BQ
MARKING DIAGRAM
10
1612x
ALYW
G
1
1612x
A
L
Y
W
G
= Specific Device Code
x = A, A1, A2, A3, B or B2
= Assembly Location
= Wafer Lot
= Year
= Work Week
= Pb-Free Package
PIN CONNECTIONS
FOVP
Feedback
V_control
V_sense
FFcontrol
1
(Top View)
pfcOK
V_CC
DRV
GND
CS/ZCD
ORDERING INFORMATION
See detailed ordering and shipping information on page 32 of
this data sheet.
Safety Features
• Separate Pin for Fast Over-voltage Protection (FOVP)
for Redundancy
• Soft Over-voltage Protection
• Brown-out Detection
• Soft-start for Smooth Start-up Operation
(A, A1, A2 and A3 Versions)
• Over Current Limitation
• Disable Protection if the Feedback is Not Connected
• Thermal Shutdown
• Latched Off Capability
• Low Duty-cycle Operation if the Bypass Diode is
shorted
• Open Ground Pin Fault Monitoring
• Saturated Inductor Protection
• Detailed Safety Testing Analysis
(Refer to Application Note AND9079/D)
© Semiconductor Components Industries, LLC, 2016
1
May, 2016 − Rev. 9
Publication Order Number:
NCP1612/D