AX-SIGFOX-MODS_16 Datasheet, PDF (1/13 Pages) ON Semiconductor – Compliant Modules

AX-SIGFOX MINISTAMP
AX-SIGFOX ANTSTAMP
Ultra-Low Power,
AT Command Controlled,
Sigfox⁾ Compliant Modules
www.onsemi.com
Overview
The AX−SIGFOX modules are ultra−low power module
solutions for a node on the Sigfox network with both up− and
down−link functionality. The AX−SIGFOX modules
connect to the customer application using a logic level
RS232 UART. AT commands are used to send frames and
configure radio parameters.
The AX−SIGFOX module comes in two flavors
• AX−SIGFOX MINISTAMP with 50 W Antenna Port
• AX−SIGFOX ANTSTAMP with On−board −5 dBi
Chip Antenna
Functionality and Ecosystem
• Sigfox up−link and down−link functionality controlled
by AT commands
• The AX−SIGFOX modules are part of a whole
development and product ecosystem available from
ON Semiconductor for any Sigfox requirement. Other
parts of the ecosystem include
♦ AX−Sigfox ultra−low power, AT command
controlled, Sigfox compliant transceiver IC
♦ Ready to go AX−Sigfox development kit with fully
functional AX−Sigfox module including Sigfox
subscription
♦ Sigfox Ready certified reference design for the
AX−Sigfox IC
♦ AX−Sigfox API IC for customers wishing to write
their own application software based on the
ON Semiconductor Sigfox Library
General Features
• 18.2 x 22 x 3 mm³ without chip antenna, 18.2 x 39.7 x
3 mm³ with chip antenna
• Supply range from 1.8 V to 3.3 V
• −40°C to 85°C
• Temperature sensor
• Supply voltage measurements
• 10 GPIO pins
♦ 4 GPIO pins with selectable voltage measure
functionality, differential (1 V or 10 V range) or
single ended (1 V range) with 10 bit resolution
♦ 2 GPIO pins with selectable sigma delta DAC
output functionality
♦ 2 GPIO pins with selectable output clock
♦ 3 GPIO pins selectable as SPI master interface
Power Consumption
• Ultra−low power consumption
♦ Charge required to send a Sigfox OOB packet at
14 dBm output power: 0.29 C
♦ Deepsleep mode current: 500 nA
♦ Sleep mode current: 1.6 mA
♦ Standby mode current : 0.5 mA
♦ Continuous radio reception at 869.525 MHz: 13 mA
♦ Continuous radio transmission at 868.130 MHz
for 14 dBm output power: 51 mA
for 0 dBm output power: 21 mA
• The output power of AX−SIGFOX modules can be
programmed in 1 dB steps from 0 dBm – 14 dBm. They
are optimized for best power efficiency at 14 dBm
output power. For modules optimized for other output
power values e.g 0 dBm transmission with 10 mA
please contact us.
High Performance Narrow−band Sigfox Receiver
• Carrier frequency 868.525 MHz
• Data−rate 600 bps
• Sensitivity: −126 dBm @ 600 bps, 869.525 MHz,
GFSK
• 0 dBm maximum input power
Highly Efficient Transmitter
• Carrier frequency 868.13 MHz
• Data−rate 100 bps PSK
• Maximum output power 14 dBm
• Power level programmable in 1 dBm steps from 0 dBm
to 14 dBm
Regulatory
• Sigfox Ready certified
• EN 300 220
© Semiconductor Components Industries, LLC, 2016
1
April, 2016 − Rev. 3
Publication Order Number:
AX−SIGFOX−MODS/D