EESX671P Datasheet, PDF (5/12 Pages) Omron Electronics LLC – Global Standard Slot-type photomicrosensors with 50- to 100-mA direct switching capacity.

EE-SX47/67
EE-SX47/67
PNP Output
Model
EE-SX67@P
EE-SX67@P-WR
EE-SX670R
EE-SX671R
EE-SX672R
EE-SX673R
EE-SX674R
Output
configuration
Timing charts
Light-ON
Incident
Interrupted
Light indicator ^ON
(red)
OFF
Output
transistor
ON
OFF
Load
(relay)
Operates
Releases
Dark-ON
Incident
Interrupted
Light indicator ^ON
(red)
OFF
Output
transistor
ON
OFF
Load
(relay)
Operates
Releases
Light-ON
Incident
Interrupted
Light indicator ON
(red)
OFF
Output
transistor
ON
OFF
Load
Operates
(e.g., relay) Releases
Dark-ON
Incident
Interrupted
Light indicator ^ON
(red)
OFF
Output
transistor
ON
OFF
Load
Operates
(e.g., relay) Releases
EE-SX470P
EE-SX471P
EE-SX472P
EE-SX473P
EE-SX474P
Light-ON
Incident
Interrupted
Light indicator ^ON
(red)
OFF
Output
transistor
ON
OFF
Load
(relay)
Operates
Releases
*1. Do not connect the L terminal to 0 V when using dark-ON operation.
Safety Precautions
Terminal
connections
Short-circuited
between
L terminal and
positive terminal
Output circuit
Open between
L terminal and
positive terminal
Light indicator
(red)
*
*1
L
Short-circuited
between
L terminal and
positive terminal
Main
circuit
OUT
IC
Load
*The terminal arrangement depends on the model.
Check the dimensional diagrams.
Open between
L terminal and
positive terminal
*1
---
Light indicator (red)
Main
circuit
OUT
IC
Load
5 to
24 VDC
5 to
24 VDC
Refer to Warranty and Limitations of Liability.
WARNING
This product is not designed or rated for ensuring
safety of persons either directly or indirectly.
Do not use it for such purposes.
Precautions for Safe Use
● Operating Environment
These Photomicrosensors have an IP50 (conforms to IEC) enclosure
and do not have a water-proof or dust-proof structure. Therefore, do
not use them in applications in which the sensor will be subjected to
splashes from water, oil, or any other liquid. Liquid entering the
Sensor may result in malfunction.
Precautions for Correct Use
Make sure that this product is used within the rated ambient
environment conditions.
● Installation
• When direct soldering to the terminals, use the following guidelines.
Soldering Conditions
Item
Soldering
iron
Temper-
ature
350°C
max.
Permissible
time
3 s max.
Remarks
The portion between the base of the
terminals and the position 1.5 mm from
the terminal base must not be soldered.
• The terminal base uses a polycarbonate resin, which could be deformed by
excessive soldering heat, resulting in damage to the product's functionality.
● Lot Number and Model Number Legend
In the following diagrams, 376d
indicates the lot number and factory
where the product was
manufactured. Do not include this
code with the model number when
ordering.
EE-SX@70@
EE-SX670
376d
Model number
Lot number and factory code
5