EESX670 Datasheet, PDF (5/13 Pages) Omron Electronics LLC – Photomicrosensor with 50- to 100-mA direct switching capacity for built-in application.

EE-SX47/67
PNP Output
Model
Output
configuration
Timing charts
Light-ON
EE-SX67@P
EE-SX67@P-WR
EE-SX67@P-CJ1-R
Dark-ON
Incident
Interrupted
Light indicator ^ON
(red)
OFF
Output
transistor
ON
OFF
Load
(relay)
Operates
Releases
Incident
Interrupted
Light indicator ^ON
(red)
OFF
Output
transistor
ON
OFF
Load
(relay)
Operates
Releases
EE-SX670R
EE-SX671R
EE-SX672R
EE-SX673R
EE-SX674R
Light-ON
Dark-ON
Incident
Interrupted
Light indicator ON
(red)
OFF
Output
transistor
ON
OFF
Load
Operates
(e.g., relay) Releases
Incident
Interrupted
Light indicator ^ON
(red)
OFF
Output
transistor
ON
OFF
Load
Operates
(e.g., relay) Releases
Terminal
connections
Short-circuited
between
L terminal and
positive terminal
Output circuit
Open between
L terminal and
positive terminal
Light indicator
(red)
*
*1
L
Short-circuited
between
L terminal and
positive terminal
Main
circuit
OUT
IC
Load
*The terminal arrangement depends on the model.
Check the dimensional diagrams.
5 to
24 VDC
Open between
L terminal and
positive terminal
*1
Incident
EE-SX470P
Interrupted
EE-SX471P
Light indicator ^ON
EE-SX472P
Light-ON
(red)
OFF
---
EE-SX473P
EE-SX474P
Output
transistor
Load
ON
OFF
Operates
(relay) Releases
*1. Do not connect the L terminal to 0 V when using dark-ON operation.
Light indicator (red)
Main
circuit
OUT
IC
Load
5 to
24 VDC
Safety Precautions
Refer to Warranty and Limitations of Liability.
WARNING
This product is not designed or rated for ensuring
safety of persons either directly or indirectly.
Do not use it for such purposes.
Precautions for Safe Use
● Operating Environment
These Photomicrosensors have an IP50 (conforms to IEC) enclosure
and do not have a water-proof or dust-proof structure. Therefore, do
not use them in applications in which the sensor will be subjected to
splashes from water, oil, or any other liquid. Liquid entering the
Sensor may result in malfunction.
Precautions for Correct Use
Make sure that this product is used within the rated ambient
environment conditions.
● Installation
• When direct soldering to the terminals, use the following guidelines.
Soldering Conditions
Item
Temper- Permissible
ature
time
Remarks
Soldering 350°C
iron
max.
3 s max.
The portion between the base of the
terminals and the position 1.5 mm from
the terminal base must not be soldered.
• The terminal base uses a polycarbonate resin, which could be
deformed by excessive soldering heat, resulting in damage to the
product's functionality.
● Lot Number and Model Number Legend
5