R88A-CPG001S Datasheet, PDF (31/52 Pages) Omron Electronics LLC – Accurax G5 Servo System

Installati_To_hn_{ree-phase, 230 VAC (for EtherCAT and MECHATROLINK-II servo drives)}
Three-phase, 230 VAC (for EtherCAT and MECHATROLINK-II servo drives)
Ω
Ω
Ω
Ω
Ω
Ω
Ω
Ω
Ω
Ω
Ω
Ω
Ω
Ω
Ω
Ω
*1 For servo drives from 750 W, B2 and B3 are short-circuited. If the internal regenerative resistor is insufficient, remove the wire between B2 and B3 and connect an
external regenerative resistor between B1 and B2.
*2 For use only with an absolute encoder. If a backup battery is connected to CN1 I/O connector, an encoder cable with a battery is not required.
*3 Wiring diagram example using the G9SX safety unit. If a safety unit is not used, keep the factory safety bypass connector installed in the CN8.
*1 For servo drives from 750 W, B2 and B3 are short-circuited. If the internal regenerative resistor is insufficient, remove the wire between B2 and B3 and connect an
Note: The input func_etio_xn_teo_rnf _ap_lin_rs_eg5_ea_nn_ed_ra7_tit_vo_e1_r3_e,_sa_in_sd_too_r u_bt_ep_tu_wt _efu_en_nct_Bio₁n_ao_nf _dpin_Bs₂1_., 2, 25 and 26, can be changed via parameter settings.
*2 For use only with an absolute encoder. If a backup battery is connected to CN1 I/O connector, an encoder cable with a battery is not required.
*3 Wiring diagram example using the G9SX safety unit. If a safety unit is not used, keep the factory safety bypass connector installed in the CN8.
Note: The input function of pins 5 and 7 to 13, and output function of pins 1, 2, 25 and 26, can be changed via parameter settings.
Accurax G5 servo systems
31