D2JW Datasheet, PDF (2/8 Pages) Omron Electronics LLC – Sealed Snap Action Switch

Specifications
■ Characteristics
Operating speed (see note 2)
Operating frequency
Contact resistance
Insulation resistance
Dielectric strength (See note 3)
Vibration resistance (See note 4)
Shock resistance (See note 4)
Ambient operating temperature
Ambient operating humidity
Degree of protection
Degree of protection against
electric shock
Proof tracking index (PRTI)
Service life
Weight
1 mm to 250 mm/second
Mechanical: 240 operations per minute max.
Electrical: 30 operations per minute max.
100 mΩ max. (Molded lead type: 140 mΩ min.)
100 MΩ min. (at 500 VDC)
600 VAC, 50/60 Hz for 1 minute between terminals of same polarity
1,000 VAC, 50/60 Hz for 1 minute between current-carrying metal part and ground, and between each
terminal and noncurrent-carrying metal part
Malfunction: 10 to 55 Hz, 1.5 mm double amplitude
Destruction: 1,000 m/s² (approx. 100G) max.
Malfunction: 200 m/s² (approx. 20G) max.
-40° to 85°C (at 60% RH) with no icing or condensation
35% to 98% (for 5°C to 35°C)
IEC IP67 (excluding the terminals on terminal models)
Class I
175
Mechanical: 1,000,000 operations min. at 60 operations per minute
Electrical: 100,000 operations min. at 30 operations per minute
Approx. 7 g (pin plunger with molded lead wire models)
Note: 1. Data shown are of initial value.
2. The values are for pin plunger type.
3. The dielectric strength values shown apply when using a separator (terminal type)
4. The values shown apply for malfunctions of 1 ms max.
■ Ratings
■ Contact Specifications
Electrical rating
0.1 A, 30 VDC (resistive load)
Note: The ratings apply under the following test conditions:
Ambient Temperature = 20±2°C,
Ambient Humidity = 65±5%,
Operating frequency = 30 operations/min.
Item
Specification
Material
Gap (standard value)
Inrush current
Minimum applicable load
(see note)
Specification
Crossbar
Gold alloy
0.5 mm
0.1 A max.
1 mA at 5 VDC
Note: Minimum applicable loads are indicated by N standard refer-
ence values. This value represents the failure rate at a 60%
(_Tλ_h6e0)erqeuliaatbioilnity_λ6le₀v=e0l.(5JxIS1C0_-5₆0/0o3p)e. _{rations indicates that a failure}
rate of 1/2,000,000 operations can be expected at a reliability
level of 60%
Engineering Data
■ Construction
Rubber seal
(silicone rubber)
Cover
(polycarbonate resin)
■ Contact Form
SPDT
SPST-NC
SPST-NO
Epoxy resin
Soldered
COM NO NC
(Black*) (Blue*)(Red*)
COM
(Black)
NC
(Red)
*Indicates the color of the lead wire.
COM NO
(Black) (Blue)
190
Sealed Snap Action Switch D2JW