MC33HB2001FK Datasheet, PDF (2/48 Pages) NXP Semiconductors – 10 A H-Bridge, SPI programmable brushed DC motor driver

NXP Semiconductors
MC33HB2001
10 A H-Bridge, SPI programmable brushed DC motor driver
• Four selectable current limits via the SPI: 5.4/7.0/8.8/10.7 A covering a wide range of
applications
• Can be operated without SPI with default slew rate of 2.0 V/μs and a 7.0 A current limit
threshold
• Highly accurate real-time current feedback through a current mirror output signal with
less than 5.0 % error
• Drives inductive loads in a full H-Bridge or Half-bridge configuration
• Overvoltage protection places the load in high-side recirculation (braking) mode with
notification in H-Bridge mode
• Wide operating range: 5.0 V to 28 V operation
• Low R_DS(on) integrated MOSFETs: Maximum of 125 mΩ (T_J = 150 °C) for each
MOSFET
• Internal protection for overtemperature, undervoltage, and short-circuit by signaling the
error condition and disabling the outputs
• I/O pins can withstand up to 36 V
4 Applications
• Electronic throttle control
• Exhaust gas recirculation control (EGR)
• Turbo flap control
• Electric pumps, motor control and auxiliaries
5 Ordering information
This section describes the part numbers available to be purchased along with their
differences.
Table 1. Orderable parts
Part number
Notes
MC33HB2001EK
[1]
MC33HB2001FK
Operating temperature
T_A = –40 °C to 125 °C
T_J = –40 °C to 150 °C
Package
32-pin SOICW exposed pad
32-pin PQFN exposed pad
[1] To order parts in Tape & Reel, add the R2 suffix to the part number.
Valid orderable part numbers are provided on the web. To determine the orderable part
numbers for this device, go to http://www.nxp.com and perform a part number search.
MC33HB2001
Data sheet: Advance information
All information provided in this document is subject to legal disclaimers.
Rev. 6.0 — 3 May 2016
© NXP B.V. 2016. All rights reserved
2 / 48